Aroma Nebulizing Diffuser
READ ALL INSTRUCTIONS BEFORE USE
KEEP THE UNIT IN A SAFE PLACE
Keep and store the unit in a safe and dry place to avoid falling or dropping into water or
other liquids.
In case of fall over, disconnect the main power supply immediately and dry the unit
completely.
Use 100% pure essential oil. Chemicals or corrosive fluid may cause damage to the
unit.
Never use high-density essential oils, such as myrrth and benzion.
When adding the essential oil, keep it away from the eyes, ears, mouth, hands and
children.
After every use of essential oil, personal cleanliness is recommended.
If the essential oil touches the eyes, ears or mouth, clean it at once, and go to see a
doctor if any serious problem happen.
If the essential oil is for pregnant woman, hypertensive or epileptic, consult the doctor
before use. Stop using it if they feel discomfort.
Essential oil may damage the contact lenses, use it with care.
Essential oil may cause damage to the case of main body, be careful when using it.
Place the unit out of reach of children, and keep away from the fire and inflammable
place.
Clean the essential oil container with alcohol before changing to use other kind of oil.
Clean the essential oil container in case of long period of nonuse, to avoid any residue
blocking up the oil suction tube after the essential oil get dry.
There are no user serviceable parts. Do not disassemble the unit.
Connect the DC jack of AC/DC adaptor to the main
body, then connect the AC/DC adaptor to the power
source. (Fig. 1)
Insert the essential oil container to the main body.
Make sure the container is installed in
place. Do not
shake the container in case of breakage. (Fig.2/3)
Add appropriate amount of essential oil to the container,
around 50 drops. (The height is half of the ail tube to
container bottom.) Do not add too much essential oil,
otherwise the oil may go into the main body through the
air tube and destroy the unit.(Fig. 4)
Put the nozzle back to the container. (Fig.5)
Press the ON/OFF button to start working. (Fig.6)
Button operation
Press the ON/OFF button once, the unit will go to the first mode: blue LED lights up,
and aroma mist comes out continuously. The unit will shut off after 3 minutes.
Press the ON/OFF button again, the unit will go to the second mode: blue LED turns
darker, and aroma mist becomes weaker. The unit will shut off after 5 minutes
continuous working.
Press the ON/OFF button again, the unit will
go to the third mode: yellow LED lights
up, and the aroma mist comes out on and off, on the cycle of 2 min on and 30 min
off. The unit will shut off after 4 hours.
Note: To maintain the good performance, it’s suggested to rest the unit after use of
8-10 times per day.
Connect the power source
Connect the DC jack of the AC/DC adaptor to the DC socket at the back of the main
body. Then connect the AC/DC adaptor to the power source.
Detach the unit from the power source
Detach the AC/DC adaptor from the power source first. Then detach the DC jack of
the AC/DC adaptor from the DC socket at the back of the unit.
Based on the Principle of hydrodynamics, the essential oil breaks into
very tiny particles and generates negative ions into the air in the same
time, making the air fresh and fragrant
Direct use of 100% natural essential oil without water and heat
3 modes of continuous and interval operation.
High efficiency, powering saving
Easy to use
PRODUCT DESCRIPTION
OPERATION INSTRUCITONS
1.Nozzle
2.Essential oil container
3.Air tube
4.Oil suction tube
5.Air hole
6.Main body
7.ON/OFF button
8.DC socket
9.DC jack
CONTANIS IMPORTANT SAFETY INFORMATION
READ AND SAVE THIS MANUAL
CHARACTERISTICS
IMPORTANT SAFETY INSTRUCTIONS
Fig.5
Fig.4
Fig.3
Fig.2
Fig.6
Fig.1
10
1
2
6
4
6
7
8
9
3