OSRAM Y-CONNECTOR SCREW User Manual

Y-CONNECTOR Screw

Description

A

Function and application

The Y-connector Screw is used to connect multiple sensors and
control units in a MULTI3 system or for connecting the compo-

nents of an EASY Color Control system.

The Y-connector Screw is attached using the integrated

A

adhesive pad.

Function

B

B

The two sockets are used to connect the system components
with the supplied connection cables. The screw terminals of the
Y-connector can be used to connect additional control units, the
pushbutton coupler or additional sensors.

Design

The Y-connector Screw is made up of the following compo­nents:

• Screw terminals for device connections (A)

C

• Modular 4p4c sockets for device connections (B)

• Adhesive pad (C)

Y-connector
Fitting instructions

Installation

Safety instructions

The Y-connector Screw must only be installed and put into
operation by a qualied electrician.

The applicable safety regulations and accident prevention

regulations must be observed.

WARNING!

Exposed, live cables.

Danger of electric shock!

• Only work on the Y-connector when the unit is

de-energised.

CAUTION!

Destruction of the Y-connector and other devices
due to incorrect installation!

• Do not install the Y-connector in the same
housing with other parts that conduct mains

voltage.

• Only connect the Y-connector to suitable

components.

• For SELV, provide for adequate insulation
against parts that conduct mains voltage.

• Do not wire the Y-connector with an external

voltage, especially not a mains voltage of 230 V.

Connecting devices

For the wiring diagram and type and number of devices that
can be connected via the Y-connector Screw, see the separate
instructions for each device. All connections of the Y-connector

Screw are interconnected via 4 pins and are equivalent.

IV 2009

Y-Connector_Screw_ma0904en_we1.01.indd

OSRAM GmbH
Kunden Service Center
Customer-Service-Center (CSC)

Steinerne Furt 62
86167 Augsburg
Germany

Tel : [phone] - 200
(kostenpichtig / charges apply)
Fax.: [phone] - 202

www.osram.com

www.osram.de

40083219166864

4008321916686

Page 1 of 2

16 mm

20 mm

40 mm

Appendix

Technical data

Combined control and
supply connection

Connection cable 2x 4-pin modular 4p4c plug

Dimensions (L x W x H) 40 x 20 x 16 mm

The CE requirements are fullled: EMC requirements as per

EN 61547, low voltage as per EN 60928.

Conformity with the relevant EU directives is
conrmed by the CE symbol.

2x 4-pin modular 4p4c sockets

EASY system:
1: Power supply

2. Sync
3: IR
4: Signal ground

MULTI 3/MULTIeco:
1: Supply voltage
2: Light measurement value
3: Motion signal
4: Signal ground

2x 4-pin screw terminals for wire
diameter

0.3 … 1.5 mm²

Basic insulation as per IEC 664

Length: 2.1 m

Page 2 of 2