OSRAM Y-CONNECTOR User Manual

Y-CONNECTOR

Description

A

Function and application

The Y-connector is used to connect multiple sensor and control
units in a MULTI3/MULTIeco system or for connecting the

components of an EASY Color Control system.

A

A

The Y-connector is attached using the integrated adhesive pad.

Function

Two sockets are used to connect the system components with
the supplied connection cables. The third, vacant socket of the

Y-connector can be used to connect additional control units or
sensors.

Design

The Y-connector is made up of the following components:

• RJ-11 sockets for device connections (A)

• Adhesive pad (B)

Y-connector
Fitting instructions

Installation

B

Safety instructions

The Y-connector must only be installed and put into operation
by a qualied electrician.

The applicable safety regulations and accident prevention

regulations must be observed.

WARNING!

Exposed, live cables.

Danger of electric shock!

• Only work on the Y-connector when the unit is

de-energised.

CAUTION!

Destruction of the Y-connector and other devices
due to incorrect installation!

• Do not install the Y-connector in the same
housing with other parts that conduct mains

voltage.

• Only connect the Y-connector to suitable

components.

• For SELV, provide for adequate insulation
against parts that conduct mains voltage.

• Do not wire the Y-connector with an external
voltage, especially not a mains voltage of 230 V.

Connecting devices

For the type and number of devices that can be connected via
the Y-connector, see the separate instructions for each device.

All sockets of the Y-connector are interconnected via 4 pins and

are equivalent.

II 2009

Y-CONNECTOR_ma0902en_we1.01.indd

OSRAM GmbH
Kunden Service Center
Customer-Service-Center (CSC)

Steinerne Furt 62
86167 Augsburg
Germany

Tel : [phone] - 200
(kostenpichtig / charges apply)
Fax.: [phone] - 202

www.osram.com

www.osram.de

40503008031352

4050300803135

Note:

An example of a wiring diagram is provided in the operating
instructions of the control units.

Page 1 of 2

35 mm

16 mm

18 mm

Appendix

Technical data

Combined control and
supply connection

Connection cable 2x 4-pin modular 4p4c plug

Dimensions
(L x W x H)

3x 4-pin modular 4p4c sockets

Basic insulation as per IEC 664

Length: 2.1 m

35 x 18 x 16 mm

The CE requirements are fullled: EMC requirements as per
EN 61547, low voltage as per EN 60928.

Conformity with the relevant EU directives is
conrmed by the CE symbol.

Page 2 of 2