
Technical Information
The smallest mains voltage halogen lamp of OSRAM
HALOPIN
Characteristics:
• Most compact mains voltage halogen
lamp
Filter
UV
• New base / lampholder system G9
• With innovative bulb-pinch technology
• With integral safety fuse, meets the safety
requirements of IEC 60432-2
• Approved to IEC 60598-1 for use in open
luminaires
• Burner with UV-Filter glass
Meets the most stringent UV-protection
thresholds (NIOSH).
Reduced UV bleaching
• 2000h average life time
• Clear and frosted version 230V u. 240V
Range:
Order code Wattage* Luminous flux** Energy Label Average life** ILCOS-code
66725
66725AM
66740
66740AM
66660
66660AM
66675
66675AM
*Maximum power consumption is nominal value + 8% acc. to IEC 60357
**may vary according to tolerances specified in IEC 60357
25W 260lm D 2000h HSGST/C/UB-25-230-G9-22
25W 230lm E 2000h HSGST/F/UB-25-230-G9-22
40W 490lm D 2000h HSGST/C/UB-40-230-G9-22
40W 460lm E 2000h HSGST/F/UB-40-230-G9-22
60W 820lm D 2000h HSGST/C/UB-60-230-G9-26,5
60W 790lm D 2000h HSGST/F/UB-60-230-G9-26,5
75W 1100lm D 2000h HSGST/C/UB-75-230-G9-26,5
75W 1050lm D 2000h HSGST/F/UB-75-230-G9-26,5
HAL M-M, Edition 6/04 1/3
Subject to alteration

Technical Information
The smallest mains voltage halogen lamp of OSRAM
HALOPIN
Light data:
Maintenance
Colour temperature
UV-radiation
Due to UV-absorbing quartz glass the bleaching is clear reduced (depending on radiated material).
Light distribution
Geometry:
Decrease of luminous flux < 20% after 75% of the nominal life time
2800 K ± 100
The irradiance is clear below the NIOSH-threshold values for skin and eye.
Available on the Light programm CD-ROM, in the directory “Eulumdat”.
D
D
C
L
H
Values in mm
Overall length L Max. 43 mm Max. 51 mm
Bulb length C Max. 38 mm Max. 46mm
LCL H 22 mm 26,5 mm
Bulb-∅ D
Please note:
Dimensions and tolerances are subject to change within the IEC regulations! Not explicitly given
dimensions cannot be evaluated by measuring lamp samples!
66725/AM; 66740/AM 66660/AM; 66675/AM
Max. 14 mm Max. 14 mm
H
C
L
HAL M-M, Edition 6/04 2/3
Subject to alteration

Technical Information
The smallest mains voltage halogen lamp of OSRAM
HALOPIN
Temperature behaviour:
Pinch Pin Mechanical spring
Burning position
Max. permitted temperature
acc. to IEC
Operating temperatures
measured free burning
Operating conditions:
Burning position
Areas of application
Dimmability
Safety Informations:
Environmental sensitivity:
Validity:
Free burning, vertical
350°C* 250°C 350°C
66725 175°C 130°C 170°C
66740 210°C 150°C 210°C
66660 220°C 140°C 220°C
66675 240°C In preparation
*Special foils on the pinch allows higher temperatures (= 370°C) than IEC 60357.
Measurement conditions:
Measurement in the most unfavourable burning position for the pinch and the pins.
Surrounding temperature: 25° (acc to DIN 5032)
Voltage: 230V
Lamp holder: BJB 25.830.100.00
Operating temperatures for free burning use are not obliging and are useful only for
orientation.
Any
For outdoor applications and operation in damp locations special approved fixtures are re-
quired.
100%
According to IEC 60598-1 "minimum safety distance" the max. temperature permitted on the
illuminated area is 90°C. This max. temperature has to be ensured by the minimum distance.
This distance has to be determined through the luminaire manufacturer by appropriate
measurements.
When placing the lamp into the holder ensure not to touch the bulb with bare hands
HALOPIN can be disposed of as houshold waste.
These technical information sheets (TI-sheets) are updated in irregular intervals. The user is
responsible to ensure that the information they have is up to date and still valid. Once a new
TI-sheet has been issued, former editions are to be seen as invalid and disposed of.
HAL M-M, Edition 6/04 3/3
Subject to alteration