Page 1
Wiring Test Tool
User guide
www.osram.us
Light is OSRAM
Page 2
NORMAL HIGH
56306
HIGHNORMAL
Boosts “NORMAL”
signal (High Bay)
NORMAL
Range: 20 ft. - 30 ft.
Overview
The Wiring Test Tool is a Lithium coin-cell battery (battery provided)
operated device used to test luminaire electrical connections during
the initial setup process.
Using the Wiring Test Tool
Press NORMAL to test luminaire switching and dimming functionality.
Luminaires in the vicinity will follow a pre-programmed OFF/ON/
DIM Down/Up sequence.
2
Notes:
i. Press HIGH only if no response is observed for NORMAL
button presses.
ii. Frequent use of HIGH button may lead to shorter battery life.
iii. Luminaires that have succesfully joined the wireless network upon
commissioning will not respond to Wiring Test Tool button presses.
Front
Back
Page 3
Troubleshooting
There are no user-serviceable parts inside the Wiring Test Tool.
Please return the device to OSRAM if service is required.
Regulatory Approvals
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Modifications not expressly approved by the manufacturer could void the user’s
authority to operate the equipment under FCC rules.
This equipment has been tested and found to comply with Industry Canada
ICES-003 Issue 5 (CAN ICES-3 (A)/NMB-3(A)).
Contains FCC ID: H79DFZM-E7220
Contains IC ID: 4259B-DFZM7220
Important Safeguards
Keep away from children. Do not disassemble and do not dispose in
fire. Dispose of the product at the end of its life cycle in accordance
with local regulations.
3
Note
Tip
!
STOP
Proper care and handling of Lithium Batteries.
CAUTION - RISK OF EXPLOSION IF INCORRECT REPLACEMENT
BATTERIES ARE USED.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
WARNING: RISK OF FIRE, EXPLOSION, OR BURNS. DO NOT RECHARGE,
CRUSH, DISASSEMBLE, HEAT ABOVE 100°C, INCINERATE.
Note
Tip
!
STOP
Page 4
© 2017 OSRAM SYLVANIA Inc.
LM S 113R2 11-17
OSRAM SYLVANIA Inc.
200 Ballardvale Street
Wilmington, MA 01887 USA
888-531-7573
www.osram.us/ds
OSRAM is a registered tradema rk of OSR AM GmbH.
Specifications subject to change without notice.
Loading...