OSP Designs MET807 Operating Instructions Manual
MET807
CHAIR w/ OTTOMAN
OPERATING INSTRUCTIONS
WarnInG
1. Do not use this product unless all screws and bolts are
securely tightened.
2. Check that all screws and bolts are tight every three
months or as needed.
3. Dispose of packing material properly. Do not use plastic cover as head covering. It may cause suffocation.
4. Do not use this product as a stepladder.
5. Use this product for its intended purpose only.
6. Intended for residential use only.
7. This chair has a 300lb weight limit.
8. This ottoman has a 200lb weight limit.
LIMITED WarranTy
OSP Designs Warrants, to the original purchaser its products to be free from defects in material and workmanship for a period of 90 days. Defects
and damage from misuse, abuse, negligence, alteration, accident, vandalism, rusting, acts of nature or any other event beyond the control of OSP
Designs is not covered. The warranty does not cover cosmetic damage that may result from normal use. Liability for incidental or consequential
damages is excluded. The user assumes all risk of injury resulting from use of this product. This warranty gives you specific legal rights, and you
may also have other rights which vary from state to state.
To make a warranty claim, contact Customer Service, provide model number, sales receipt and description of the problem. It is the customer’s
responsibility to prepay freight on any components returned to the factory. OSP Designs will pay return freight on components covered under
terms of warranty.
Our quality standards are among the highest in the industry. Sometimes, no matter how hard we try, there are times when hardware is missing.
Our Parts Department will do everything possible to promptly remedy the problem. Contact us via email parts@officestar.net, by Fax
1-909-930-5629, or toll free parts number 1-800-950-7262, Monday through Friday 8:00 a.m. - 5:00 p.m. Pacific Time. OSP Designs P.O. Box
3520 Ontario, California 91761 USA
IMPORTANT NOTE:
1. Use hand tools only for assembly as power tools may cause damage
2. Carefully remove any staples used for packaging.
MET807
CHAIR w/ OTTOMAN
ASSEMBLY INSTRUCTIONS
STEP 1
3
DETAIL A
3
2
1
2
1
PART QTY
1. Chair Body ...................1
2. Leg. . . . . . . . . . . . . . . . . . . . . . . . . 4
3. Screw .......................4
4. Allen Wrench (not shown) .......1
Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.
STEP 1 Attach one Leg (2) to each bottom corner of Chair Body (1) using one Screw (3) for each Leg (2), SEE DETAIL A.
FULLY TIGHTEN ALL SCREWS (3) USING ALLEN WRENCH (4).
ATTENTION: MAKE SURE ALL SCREWS (3) ARE FULLY TIGHTENED BEFORE USING CHAIR.
© Office Star Products August 2012
Loading...