OSP 73631, 73633, 73632, 73638, 73631M Operating Instructions Manual

...
73631 / 73633 / 73632 / 73638 / 73639 / 73631M
ARMLESS VISITOR’S CHAIR
OPERATING INSTRUCTIONS
FEATURES
• PNEUMATIC SEAT HEIGHT ADJUSTMENT To raise seat remove pressure from seat and lift lever (1).
To lower seat height sit on chair and lift lever (1). NOTE: It is normal for chair to slightly lower under body weight.
• LOCKING TILT ADJUSTMENT
For individual comfort, this chair has been equipped with
an adjustment that will allow the user to change the tension of the tilting feature. Turn knob (2) clockwise to increase tension and counter-clockwise to decrease or ease the tension. To lock return chair to the upright position and push lever (1) in. To unlock pull lever (1) out.
NOTE: Be careful not to loosen the back tilt adjustment knob
completely.
WARNING
1
2
OSP FURNITURE RECEPTION SERIES LIMITED WARRANTY
OSP Furniture Reception Series are warranted* from date of purchase against failure due to material and workmanship as follows:
• 5 years on structural integrity of frame.
• 3 years on upholstery fabric against wear and deterioration (except leather).
• Leather is not warranted against routine scratching and scuffing, as leather is subject to minor blemishes in use.
which vary from state to state.
Our quality standards are among the highest in the industry. Sometimes, no matter how hard we try, there are times when parts are damaged or missing. Our Parts Department will do everything possible to promptly remedy the problem. Contact us via e-mail parts@officestar.net, by Fax 1-909-930-5629, or toll free parts number 1-800-950-7262, Monday through Friday 8:00 a.m. - 5:00 p.m. Pacific Time.
1. Use this product only one person at a time.
2. Do not use this chair unless all bolts screws and knobs are securely tightened.
3. Check that all bolts screws and knobs are tight every three months or as needed.
4. Do not overturn back tilt knob when decreasing tension.
5. Dispose of packing material properly. Do not use plastic cover as head covering. It may cause suffocation.
6. Do not use chair as a stepladder.
7. Use this chair for its intended purpose only.
8. Use mild detergent only for cleaning.
73631 / 73633 / 73632 / 73638 / 73639 / 73631M
ARMLESS VISITOR’S CHAIR
ASSEMBLY INSTRUCTIONS
5
8
4
6
7
3
PA RT QTY
1. Base .......................1
2. Casters .....................5
3. Pneumatic Cylinder ............1
4. Seat Plate ...................1
5. Chair Body ...................1
1
6. Short Seat Plate Screws ........2
7. Long Seat Plate Screws ........2
8. Spacer ......................2
9. Allen Wrench (not shown) .......1
2
Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.
STEP 1 Insert five Casters (2) into Base (1), push hard until you feel or hear the Caster (2) snap into place. Insert Pneumatic Cylinder (3) into Base (1). STEP 2 Attach Seat Plate (4) to Chair Body (5) with the tension adjustment knob towards the front of the chair using two Spacers (8), two Short Seat Plate
Screws (6) and two Long Seat Plate Screws (7). FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH (9).
STEP 3 Place the assembled seat on top of Pneumatic Cylinder (3) and apply downward pressure. ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING CHAIR.
© Office Star Products June 2014
Loading...