OSD Audio BTP-650 User Manual
CONTENT:
Master Speaker
Bluetooth Receiver
Internal Stereo Amplifier
®
Patio Speakers
Pairing Speaker
110-240V
Power Supply
for Master Speaker
30’ Speaker Wire
To connect the speakers
together for stereo R&L
BTP-650
All Weather Bluetooth Patio Speaker
System Quick Start Guide
“State of the art” Bluetooth
Operation Connects to any
Bluetooth enabled device
Sync to bluetoothenable devices like
smartphones and
tablets
Power on
Blue LED
Basic Setup of the BTP-650:
1) Determine the ideal location where the Patio Speakers are not exposed directly to the elements. Note:
speakers typically should be placed between 8 to 12 feet apart for proper stereo separation.
2) The Master Patio Speaker needs to be located near an AC outlet where you can connect the Power
Supply to the Master Speaker in order provide the electrical current needed for the Internal Stereo
Power Amplifier and Bluetooth Receiver.
3) The Pairing speaker must be connected to the Master Speaker with the 30-foot Speaker Cable that is
supplied with the kit. The length of the speaker cable can be cut down for an exact fit but should not be
extended beyond 30 feet.
Pairing Speaker
10ft
Power Supply
Master Speaker
15ft
30ft
Bluetooth Range
60-75 feet
Range may vary:
Distances, both unobstructed
and obstructed, may differ
depending on device you are
syncing up to the BTP-650.
Make sure both your Bluetooth device and the
OSD BTP-650 are turned on!
To pair two Bluetooth enabled devices, both the Bluetooth
Device and the BTP-650 must be turned on and fully powered
or fully charged. Bluetooth controls are typically found in the
device’s Setting or Connections menu. The BTP-650 will output
a Bluetooth Sync code that will be received by the Bluetooth
Device. Settings such as Volume, Mute, etc., will be controlled
directly from your Bluetooth phone, tablet or other device.
Only one connection at a time:
The BTP-650 syncs with only one device at a time. You must
disconnect the current device before Syncing to another device.
Loading...