Page 1
ToolsRequired: Flatheadscrewdriver,Phillipsscrewdriver, pliers,wirecutters, wire strippers,electricaltape, safety glasses.
LightSource:
EstimatedAssembly Time:
Preparation:
present.Ifany parts aremissingor damaged, donotattempt to assemble,install,or operate thefixture.Contact customer serviceforreplacement
parts.
LED30W
20-30minutes
Identifyandinspect all partsbeforebeginning installation. Checkpackagecontent list anddiagramsbelow to besureall parts are
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
Package Contents
Shade
D
Inner
Backplate
A
x1
Mounting
Screw
B
x4
STEP 1 Install Inner Backplate and Fixture Body-
A. Pass the supply wires through Inner Backplate (A). Attach Inner
Backplate (A) to Outlet Box with the head of Green Ground Screw
facing you. Secure it with Outlet Box Screws (not included). Tighten
until snug
B. Race all supply wires through the Inner Backplate (A) as shown.
Refer to Step 2 for wiring connections.
C. Attach Fixture Body (C) over Inner Backplate (A) and secure with
Lock Screws (B). Tighten until snug with screwdrivers.
.
C
Figure 1
Fixture
Body
C
x1
B
x1
Outlet Box
A
E
Bracket
F
x2
Outlet
Screw
Lock
Screw
x4
Box
STEP 3 Install Shade to Fixture Body-
A. Insert Shade (D) into the Shade Holder properly.
B. Place Bracket (F) over the side of the Shade Holder, line up the hole
on the Bracket (F) and the mounting hole on the Shade Holder,
secure by threading Lock Screw (E) into the mounting hole, tighten
until sung.
Your fixture is now assembled and ready to use. Enjoy!
E
F
Shade Holder
D
FINISH: POLISHED CHROME
19”
4.5”
STEP 2 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. (Connectors are not included with fixture.) Twist
connectors until wires are tightly joined together. Wrap each
connection with approved electrical tape and carefully stuff all the
connected wires between Inner Backplate (A) and Fixture Body (C).
White wire
from supply
Black wire from
supply (or Red)
Ground wire
from supply
Figure 2
White wire
from fixture
Black wire
from fixture
Ground wire
from fixture
4.5”
1
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/2"
NO.
1
1of1
PART NUMBER
REPLACEMENT PART DESCRIPTION
SHADE
6.5”
REQ.
1
Loading...