Page 1
INSTALLATION INSTRUCTIONS
Fig. 2
HANGING THE FIXTURE
1. Carefully remove the fixture from the carton and check
that all parts are included as shown in the illustration.
2. Shut off power at the circuit breaker and remove old
fixture including the mounting hardware
SUGGESTED INSTALLATION (Fig. 1)
3. Attach the mounting plate (B) to the Junction box (F)
using screws (D) (Screw Size: 8-32*1/2”L). The side of
the mounting plate marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
4. Connect the driver input wire with housing wire as
shown in Fig.2, making sure that all wire connectors
(C) are secured.
5. If your outlet box has a green or bare copper ground
wire, connect the fixture’s ground wire to it. Otherwise,
connect the fixture’s ground wire directly to the
mounting plate (B) using the green screw provided.
After wires are connected, tuck them carefully inside
the junction box (F).
COMPLETING THE INSTALLATION (Fig. 1)
6. Connect the canopy (A) with the mounting plate (B)
and secure with mounting screws (E).
7. Adjust the length of the cable to pull or push until the
desired length by pushing down(G).
Your installation is now complete. Return power to the
junction box and test the fixture.
IMPORTANT: Fixture should be installed by a qualified electrician to
ensure proper wiring and installation.
Dimmable with ELV and/or LED compatible wall dimmer switches.
Fig.1
- Mounting plate
- Ground screw
- Mounting screws*2pcs
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
FOR LED Chandelier/Pendant Light
WARNI N G! SHUT PO WER OFF AT FUSE OR CIR CUI T B REAKER.
AV E R TI S S E M E N T ! C O U P ER LE C OU R AN T A U N I V E A U D E S F U S IB L E S O U D O DI SJ O N CT E UR
Page: 1/2
Page 2
Fig.3
Replacing LED module (Fig. 3)
The LED module can be replaced by a qualified
electrician without cutting of wire and without damage
to any decorative element to which the fixture is
attached.
a. Shut off power. Loosen screw (E) to disconnect
the canopy (A) from the mounting plate (B)
b. Disconnect the wire connectors (H) and remove
the protective rubber tube (L)
c. Loosen the wire clip (I).
d. Pushing down the nod (G) and pull the cable wire
out.
e. Loosen screw (K) and metal (O) to disconnect the
aluminum ring (Q) (with LED module inside) from
the acrylic ring (P)
f. Reverse steps a-e for installing the new LED
module and make sure that all wire connectors
(H) are secured and with electronic tape for
insulation.
Note: The LED module should be provided by a
specified supplier.
Page 2/2
Loading...