Page 1
INSTALLATION INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
WARNING
●Risk of shock, do not plug in the unit before assembly..
●Do not exceed the maximum wattage rating.
MOUNTING THE LUMINAIRE, PLUG VERSION (Fig.1 & Fig. 2)
For hardware version see Fig. 3 & Fig. 4
1. Carefully unpack your new fixture and lay out all the parts on
a clear area. Take care not to lose any small part s nece ssary
for installation.
2. Drill two holes in the proper position on the wall according to
the mounting location of the fixture.
3. Secure the wall plate (K) to wall using the screws (B) and the
plastic anchors (D).
4. Place the shade (F) onto the socket, then screw the glass
bowl (E) to the socket until tighten.
5. Install the bracket (G) using screws (H) and plastic anchors
(L). Fix the cord (I) into the bracket (G), then snap the cord
cover (J) into the bracket (G) tightly.
6. Install the bulb into socket in accordance with the fixture’s
specifications.(
WATTAGE RA TING!)
DO NOT EXCEED THE MAXIMUM
Fig.1
Fig.2
IMPORTANT SAFETY INSTRUCTIONS
1. This portable lamp has a polarized plug (one blade is wider than the other) as a safety feature to reduce the risk
of electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless plug
can be fully inserted. Do not alter the plug.
2. The lamp uses 3-way switch on socket. Please use Med. Base, 3-way, 30/70/100W bulb. The lamp also uses
1-3W LED bulb and the on/off switch is on the face plate. Do not look directly at lighted LED lamp.
Page 1
Page 2
O
O
O
MOUNTING THE FIXTURE, HARDWARE VERSION
(Fig. 3 & Fig. 4)
1. Shut off power at the circuit breaker and remove old
fixture from wall, including the crossbar.
2. Remove the cord and plug by disconnecting the wire
nuts to the cord. (CAUTION: CAN NOT GO BACK TO
PLUG VERSION ONCE THE CORD AND PLUG ARE
CUT OFF)
3. Remove the mounting plate for portable version (Fig
1.A)
4. Secure the mounting bracket (A) to the Outlet Box using
the screws (B). The side of the mounting bracket
marked “GND” must face out (Fig.3).
CONNECTING THE WIRES (Fig. 5)
5. Connect the electrical wires as shown in Fig.5, making
sure that all wire connectors are secured. If your outlet
has a ground wire (green or bare copper), connect the
fixture’s Ground Wire to it. Otherwise, connect the
fixture’s Ground Wire directly to the mounting bracket by
using the Green Screw provided.
FINISHING THE INSTALLATION (Fig. 4)
Fig.3
Fig.4
6. Place wall plate (K) over the mounting bracket (A) then
secure them tightly with two screws (C) on both sides of
wall plate.
7. Insert the filler plug (M) into the hole on the bottom of the
wall plate (K).
8. Install the bulb into socket in accordance with the
fixture’s specifications. (DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!)
Your installation is now complete. Return power to
the outlet box and test the fixture.
Fig. 5
FIXTURE
WIRES
Black or
Smooth
H
WIRES
Black
(Hot)
USE
FIXTURE
WIRES
White or
Ribbed
H
WIRES
White
(Neutral)
USE
FIXTURE
WIRES
Bare
Copper
(Ground)
USE
H
WIRES
Green
(Ground)
Loading...