Safety and Installation Instructions
LED Flush mount light
Edge lit LED fixture
With Integrated Dimmable Driver
Thank you for purchasing our product. This fixture has
been manufactured from components with advanced
optoelectronics to ensure high reliability and long life.
Before assembling please read this Operation Manual
carefully and save in a safe place for future reference.
Please note that all electrical connections must be in
accordance with local and National Electrical Code
standards as well as local building codes. In case you are
not familiar with proper wiring connections and building
codes, consult a qualified electrician.
RISK OF ELECTRIC SHOCK – THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE
1.
WITH APPLICABLE INSTALLATION CODES BY A PERSON FAMILIAR WITH MENTIONED
ABOVE CODES AND HAZARDS INVOLVED. DISCONNECT POWER AT CIRCUIT BREAKER
OR FUSE BEFORE INSTALLING OR SERVICING.
2. BEFORE USE OF THE PRODUCT CAREFULLY READ THE WHOLE OPERATION MANUAL.
3.
THE PRODUCT IS SUITABLE FOR BOTH DAMP AND WET LOCATIONS.
4.
ASSEMBLE THE PRODUCT ONLY WITH THE USE OF PARTS PROVIDED AND THE HOUSING;
All Rights Reserved.
IMPROPER ASSEMBLY MAY RESULT IN DEVICE FAILING WHICH COULD DAMAGE THE PRODUCT,
5.
PERSONAL PROPERTY OR CAUSE INJURY.
ASSEMBLY SHALL FOLLOW WITH ACCESSORIES DELIVERED WITH THE SET ONLY.
6.
THE DEVICE IS NOT A TOY, KEEP OUT OF REACH OF CHILDREN.
Specifications:
Flush Mount Light
Operating Voltage: 120V
Dimming: With most LED rated controls
Power consumption: 10.5W/13.5W/18.5W
Turn-o ff/ disconnect power at circuit braker.
STEP 1: Remove bracket from back of fixture.STEP 2:
Attach connector (provided) to AC cable from
junction box: L side to Black side wire.
N side to White AC wire.
Installed-Congratulations...
Enjoy the light!
Dimming
This product is compatible with most residential type dimmers available on the market.
The dimming performance will depend on kind of dimmer and dimmer settings.
Attach the bracket to junction box using
STEP 3: Make ground connection. Next simply „click”
2 screws (provided). Pull the AC cable with
connector trough the bracket center hole.
STEP 4:
the two sides of the orange wire connector
together.
Visit our website for an up to date list of compatible dimmers.
Cleaning
• Clean with a soft or damp cloth. While cleaning with the damp cloth make sure
the power is off.
• Do not clean with abrasives.
5 Year limited warranty
The purchased product is covered with a 5 year warranty in respect of any defect in
material or workmanship after purchase date.
We shall bear no responsibility on account of guarantee, as well as shall bear no
liability for any faults, in case of improper operation, use negligence, accident or
exposure to natural hazard, or excessive use over the limits specifed for the unit,
or if any unauthorized alteration or repair followed.
Aling slots on the edge of fixture with the
STEP 5: Push and feed all wires up into junction box
Pressure Clips on the mounting bracket and
PUSH to lock fixture in place.
2 3
STEP 6:
as you raise the fixture into place.
For wet location usage, seal/caulk the edge
of the fixture to the ceiling with waterproof
sealant.
Loading...