Orren Ellis ORLS5148 Installation & Assembly

Page 1
Simple Drum LED Flush Mount
Safety recommendations
Risk of electric shock – this product must be installed in accordance
1. with applicable installation codes by a person familiar with mentioned above codes and hazards involved. disconnect power at circuit breaker or fuse before installing or servicing.
2. Before use of the product carefully read the whole operation manual.
3. The product is purposed for interior use only, suitable for wet locations.
4. Protect the product against direct contact with water.
5. Assemble the product only with the use of parts provided and the housing; improper assembly may result in device failing which could damage the product, personal property or cause injury.
7. The device is not a toy, keep out of reach of children.
Specifcations:
Light Disk Operating Voltage: 120VAC Dimming: Triac
Power consumption: 16.5W / 21.5W Life span: 50,000h
Page 2
STEP 1a: For 4'' Jbox, 7'' fixture can be installed to Jbox
direclty without crossbar. For 2.75'' Jbox, 10''fixture can be installed to Jbox direclty without crossbar.
OR
STEP 1b: Attach bracket to jbox using 2 screws
(provided). 1. For 2.75'' and 3" Jbox, install 7'' fixture by attaching 2 long screws to 4'' holes of crossbar according to marking. 2. For 3'' and 4'' Jbox, install 10'' fixture by attaching 2 long screws to 2.75'' holes of crossbar according to marking.
4" 2.75"
10" fixture7" fixture
STEP 8:
STEP 7: Align two tabs on inside wall of light base
to threads on acrylic lens. Turn CLOCKWISE untill lens locks in place.
Fixture installed.
Dimming
This product is compatible with most residential type dimmers available on the market. The dimming performance will depend on kind of dimmer and dimmer settings.
Cleaning
• Clean with a soft or damp cloth. While cleaning with the damp cloth make sure the power is off.
• Do not clean with liquids or abrasives.
STEP 2: Remove acrylic lens from base by turning
counter clockwise. Remove sticker.
STEP 3: Connect wires to AC cables from junction box
with wire nuts (provided): L side to Black AC wire N side to White AC wire. Ground to Ground wire
5 Year limited warranty
The purchased product is covered with a 5 year warranty in respect of any defect in material or workmanship after purchase date. We shall bear no responsibility on account of guarantee, as well as shall bear no
liability for any faults, in case of improper operation, use negligence, accident or exposure to natural hazard, or excessive use over the limits specifed for the unit, or if
any unauthorized alteration or repair followed.
STEP 5: Carefully push and feed all wires back in to the
Jbox. Align the two mounting holes on the fixture body to the two long screws of the crossbar.
STEP 6: Twist clockwise and push to lock fixture in place.
Secure base to crossbar by tightening two screws. For wet location usage, please caulk the edge of fixture with glue to ceiling.
2 3
Loading...