INSTALLATION INSTRUCTIONS
Tire Pressure Monitor System (TPMS) Sensor Assemblies
WARNING
Read all instructions and warnings before installation. Refer
to Mitchell Manual for installation specifications (excluding
Ford Banded Sensors). Professional installation only. These
Tire Pressure Monitor System Sensor assemblies are
replacement or maintenance parts for motor vehicles that
have a factory installed Tire Pressure Monitoring System
(TPMS).
Caution
Each TPMS sensor is designed and manufactured to operate in a
specific motor vehicle year, make and model, using the proper
frequencies to communicate with the motor vehicle TPMS system.
Only install TPMS sensors designated for your specific motor vehicle
year, make, and model. Improper installation will cause the motor
vehicle TPMS system to fail to operate properly.
Do not install sensors in damaged wheels. Upon completion of
installation, test the motor vehicle TPMS system using procedures
described in Mitchell1 Manual (excluding Ford Banded Sensors) to
confirm proper installation. If the TPMS system fails to operate
properly, check all installation procedures to ensure proper
installation and retest. If the TPMS system continues to fail to
operate, immediately consult with an authorized motor vehicle
dealership.
If the OEM equipment wheels or tires are not used it is the
responsibility of the vehicle owner to ensure that the TPMS system is
functioning properly. The vehicle owner expressly assumes sole and
complete responsibility for the TPMS and vehicle function if the OEM
equipment wheels and tires are not used. Failure to ensure that the
TPMS system is functioning properly can result in severe injury or
death.
It is MANDATORY to replace the sensor if it is externally damaged.
WARNING FAILURE TO FOLLOW INSTRUCTIONS OR THE USE OF IMPORPER
TPMS SENSORS MAY RESULT IN THE MOTOR VEHCILE TPMS FAILURE
CAUSING POPERTY DAMDAGE PERSONAL INJURY OR DEATH.
T
r
T
r
y
Temperat
Temperat
y
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference
received, including interference that may cause undesired operation.
OERSX2 Sensor Specification
Sensor’s Specification
Battery
Battery Voltage 3.0 V
Storage
Operation
Operation Frequency
Pressure Monitoring
Pressure Reading Accurac
life 8years normallyuse.
Temperature -50℃to 150 ℃
Temperature -40 ℃to 125 ℃
ansmission Frequency
ure Monitoring
ureReading Accurac
433.92MHz
ansmit 1 signal each 30 sec.
Range 0 ~ 800kPa
±
10kPa
Range-50℃to 125 ℃
±
4℃
Notice : The changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
IMPORTANT NOTE:
To comply with the FCC RF exposure compliance requirements, no change to
the antenna or the device is permitted. Any change to the antenna or the
device could result in the device exceeding the RF exposure requirements and
void user’s authority to operate the device.
Loading...