ORION XTR500.4 Owners Manual

Owners Manual: (revised)

Orion Xtreme 500.4 4-channel amplifier.

Bridging the Xtreme 500.4

1. Use the Left + for Positive.

2. Use the Right - for Negative.

Setting the Input of the Xtreme 500.4 Amplifer:

 The amplifier will accept up to 5volts of input
signal and will make full power with as little as 1v of
input. The 500.4 uses 2 gains, 1 for the Front
Channels and 1 for the Rear Channels.

Setting the Crossover on the Xtreme 500.4:

The Xtreme 500.4 has a
fully adjustable 12dB per
octave highpass or lowpass
crossover. The frequencies

OFF

HP

LP

are fully adjustable between
45hz and 5khz.

SETTING THE OUTPUT ON THE XTREME 500.4:

There are 3 ways to configure the
output of the Xtreme 500.4 amp.

1. STEREO(ST) is for a conventional
two channel stereo output .

ST

SUM(L+R)

MONO

2. SUM(L+R) is for mono output. This
combines the signal from the left and
right RCAs.

3. MONO takes information from the
right RCA only.

WIRING DIAGRAM FOR 500.4

REMOTE

RF(-)

RF(+)

LF(-)
LF(+)

RL(+)
RL(-)

RR(+)
RR(-)

Amp Model

Xtreme 500.4

For questions on this or any other Orion Products, call Technical Support at 1-480-705-5600.

4ohm Power

50 x 4

Lowest Recommend
Impedance in Stereo

2ohm

Fuse Size

(2) 20 amp

S/N

100dB

THD

0.03%

Frequency
Response

10hz to 30Khz
+/- 0.5dB

Dimensions L x W x H

13" x 10.25" x 2.25"