USER MANUAL FOR BODY WORM CAMERA OT-T07
5
Getting Started
1) Power on/off
Slide Switch has 3 switches, “OFF”,”SBY” (Stand By) and “REC(Record)”. Slide from OFF to SBY to
turn on camera. A green indicator on top of the unit will turn on and remain green while the unit is
in standby mode. Slide to OFF and camera will turn off.
2) Video Recording:
To record a video, slide the switch to REC. The unit will emit THREE audio chirps and a red working
indicator on top of the unit. Will turn on and remain red until recording is ended. Slide from REC to
SBY to stop recording, the unit will emit TWO audio chirps, and the red indicator will change to
green.
3) Taking Photo:
To take a photo, press the “Photo” button located on the right side of device(when camera is held
facing toward the front). The unit will emit ONE audio chirp.
4) Wi-Fi:
User can set Wi-Fi via PC software ”Cam Manager”. When Wi-Fi is On, there will be white indicator
on the top of unit turned on.
Note: When white indicator is flashing, it means Wi-Fi is being activated.
5) Fill-light:
To turn on fill-light, double-press “Photo” button. Then, double press “Photo” button again to fill-
light.
6) Manual IR Switch:
When you want to turn on/off IR light manually, press and hold “Photo” button for about 3
seconds.
7) Charging:
Place the camera in the dock, then connect the dock to an electrical outlet using USB cable
(included in the accessories). When the camera is being charged, the charging indicator located on
top of the unit will be blue, and then after fully charged, the charging indicator will be off.
8) Data Browsing and Management:
Place the camera in the dock, then connect the dock to PC using USB cable (included in the
accessories), then use Cam Manager. Regarding how to use Cam Manager, please check “Cam
Manager Software Manual” in the following part.
9) How to Reset?
If you are having problems with your device, please try and reset the camera using the reset
button.
Note: Use a paper clip to press the reset button. You will hear a "click" after the button is pressed