ORION CO430, CO260, CO230, CO2100 Owners Manual

Owners Manual: (revised)

1st series COBALT amplifers, including: CO230, CO430, CO260, CO2100

Bridging of the COBALT Amplifier:

1. Use the Right + for Positive.

2. Use the Left - for Negative.

Setting the Input of the Cobalt Amplifer:

 The amplier will accept up to 5volts of input signal. The amplifer will make full power with as little as 1v of input. The CO230, CO260 and CO2100 use 1 gain for the Left and Right channel. The CO430 uses 2 gains, 1 for the Front Channels and 1 for the Rear Channels.

Your Cobalt amplifer may differ from the picture.

WIRING DIAGRAM FOR CO430

REMOTE

RR(+)

RR(-)

LR(-) LR(+)

FL(+) FL(-)

FR(-) FR(+)

Setting the Crossover on the CO2100:  The CO2100 is the only Cobalt amplifer in this

series that offers a crossover. The Crossover only operates in MONO and is only a Lowpass crossover. The Crossover is only active through the RIGHT input. The Crossover is varible from 35hz to 200hz at a slope of 12dB.

WIRING DIAGRAM FOR CO230, CO260,CO2100

REMOTE RIGHT (-)

RIGHT (+)

LEFT (-) LEFT (+)

Amp Model

CO230

CO430

CO260

CO2100

For questions on this or any other Orion Products, call Technical Support at 1-480-705-5600.

4ohm Power

30 x 2

30 x 4

60 x 2

100 x 2

Lowest Recommend Impedance in Stereo

2ohm

Fuse Size

15 amp

30 amp

20 amp

30 amp

S/N

100dB

THD

0.03%

Frequency Response

10hz to 30Khz +/- 0.5dB

Dimensions L x W x H

7" x 8.125" x 2.125"

11" x 8.125" x 2.125"

9" x 8.125" x 2.125"

13" x 8.125" x 2.125"