Organic Lighting Systems liniLED Top User Manual

LED strip manual

liniLED® Top

BEND

R

1.2 in

F

FROST

RoHS

24

V DC

SEA

IP40/IP68

UV

POOL CL

CRI

80

+

CLEANING

POOL CL

MAC

ADAM

2

S D C M

LED strip Top

3. General

3. Installation

3. Operation and use

3. Warning

3. Cable selection

4. Area advice

5. Product care and handling
6/7. Cutting instructions
8/9. Soldering
10/11. Connect IP40

12. Power supply

13. Symbols

3

LED strip manual | liniLED® Top

General

Read the instructions and safety precautions before installation, usage and storage of the products to secure safety of the user and reliability of
the product.

- Hand over the instructions to the end-user and those responsible for installation and usage.

- Organic Lighting cannot be held responsible for improper handling, product installation, usage or storage.

Installation

- Attention: The power has to be switched off the main power supply or the connection before installation. Not doing so may damage the
product.

- Installation has to be done by a professional with knowledge of electrical circuits or a specialised maintenance person known with valid
directives.

- General and local construction-, safety- and installation regulations should be respected.

- Products may solely be installed in the areas according to their prescribed IP-rating, temperature range and chemical resistances.

Operation and use

- Use a suitable LED power supply / driver: 24 V DC constant voltage.

- Do not drive the product on other voltages than described in their datasheet/products specifi cations.

Warning

This product comes with a 2 year warranty.

Warranty void if:

1. The installation guide has not been consulted (installation mistake).

2. The installation is not done by a certified installer.

3. The invoice cannot be shown and/or has been altered.

4. Damage is caused by negligence, abnormal use or improper handling, use, maintenance and/or cleaning of the

product.

Cable selection

The liniLED® LED strips need a minimum voltage at the beginning of the LED strip to function according to the specifi cations. Please refer to
the specific Wire Gauge specification for maximum cable length based on the cable thickness and power supply voltage.

4

Wet environment (IP68) | liniLED® Top IP68 Kit *

Submersible, chlorine resistant (IP68) | Mirror Welded Connector

Area advice

Indoor environment (IP20) Solder

Indoor environment (IP40) | liniLED® Top Connector set

Depending on the area where the liniLED® LED strip is installed we oer a range of solutions to cope with external factors. The product portfolio
includes a range of IP40 and IP68 connectors. Below the dierent connectors are displayed for use in dierent environments.

5

LED strip manual | liniLED® Top

Do not bend the LED strip sidewards.

Do not twist the LED strip.

The LED strip has to be unreeled on a horizontal surface at the time of installation. Do not unreel the spool of LED strip before installation.

LiniLED TOP Product care and handling

1.2 in

1.2 in

Do not compress or stretch the LED strip.

Maximum bending radius is 1.2 inches

. Only bend up or downward.