1
USER MANUAL
Air Purifier
With Pre-filter, HEPA, Activated Carbon, UVC
CF-8410
2
READ AND SAVE THESE INSTRUCTIONS
SAFETY INSTRUCTIONS
Failure to comply with the warnings listed below may
result in electric shock or serious injury.
This product should only be used in accordance with the specifications outlined in
this manual. Usage other than what has been specified here may result in serious injury.
When using electrical appliances, the following basic precautions should always be
taken to reduce the risk of fire, electric shock and injury to persons.
•
Read all instructions before using appliance.
•
IMPORTANT - This appliance has a polarized plug (one blade is wider than
the other). To reduce the risk of electric shock, this plug is intended to fit in a
polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician. Do not
attempt to defeat this safety feature.
•
To avoid fire or shock hazard, plug the appliance directly into a correct AC
electrical outlet.
•
Keep the cord out of heavy traffic areas. To avoid fire hazard, NEVER put
the cord under rugs, or near radiators, stoves or heaters.
•
To protect against electrical hazards, DO NOT immerse in water or other
liquids, and do not use near water.
•
As children are not able to recognize the hazards associated with the usage
of electrical appliances, always supervise children when they are near the unit.
•
Always unplug the air purifier before moving it, opening the grill, changing
filters, or cleaning, or whenever the air purifier is not in use. Be sure to unplug
it by pulling on the plug and not the cord.
•
NEVER drop or insert any object into any openings.
•
DO NOT run cord under carpeting.
•
DO NOT cover cord with throw rugs, runners, or similar coverings.
•
DO NOT route cord under furniture or appliances. Arrange cord away from
traffic areas where it will not present a tripping hazard.
3
•
DO NOT operate any appliance with a damaged cord or plug, if the motor
fails to rotate, after the appliance malfunctions, or if it has been dropped or
damaged in any manner. Get support from Customer Service for maintenance
and repairs.
•
Use appliance only for intended household use as described in this manual.
Any other use not recommended by the manufacturer may cause fire, electric
shock or injury to persons.
•
DO NOT use outdoors.
•
DO NOT place anything on top of the unit.
•
NEVER block the air openings, grills or outlets, or place on a soft surface
such as a bed or sofa, as this could cause the unit to tip over, blocking the air
intake or outlet opening.
•
DO NOT attempt to repair or adjust any electrical or mechanical functions
on this unit. Doing so will void your warranty. The inside of the unit contains
no user serviceable parts. All servicing should be performed by qualified
personnel only.
•
WARNING: To reduce the risk of fire or electric shock, do not use this fan
with any solid-state speed control device.
TECHNICAL SPECIFICATIONS
Rated Voltage: AC120 V, 60 Hz
Rated Power: 55 W
Noise Level: 32 dB (L), 40 dB (M), 55 dB (H)
UV Light: Wavelength: 254 nanometers
Lamp life: Approx. 20,000 hours
Dimensions: L x W x H: 12.7 x 7.3 x 16.1 in (323 x 185 x 410 mm)
Weight: 9.7 lb (4.4 kg)
CADR: ≥120 cfm (0.3 μm AHAM standard)
Applicable Area: Medium size
4
AIR CLEANING SYSTEM
Improve your indoor air quality with the new Air Cleaning System. Multiple levels of
cleaning include a combination HEPA filter that captures allergens, and an Activated
Carbon filter to remove odors. UV-C light technology enhances the killing of germs.
PRE-FILTER: Captures initial dust and allergen particles.
ACTIVATED CARBON FILTER:
Absorb formaldehyde, benzene and other noxious gases.
HEPA FILTER: Captures dust, smoke, pollen and other allergens.
UV-C LIGHT: Destroys micro-organisms such as germs, viruses, bacteria and fungi
(such as mold toxins).
PRODUCT COMPONENTS
UV-C lamp
Front cover
Air outlet
3 in 1 filter (Pre-filter, Activated
Carbon filter, HEPA filter)
Touch panel
Main unit
5
BEFORE OPERATING THE AIR PURIFIER:
1. Carefully remove your air purifier from the box and plastic bag.
2. Place the air purifier on a firm, level and flat surface.
3. For proper air flow, locate the unit at least 1 foot from any wall or furniture.
4. Make sure none of the grills are blocked.
5. Before using for the first time, remove the filters, then remove and discard the bags.
Replace the filters.
6. Plug the power cord into a right voltage AC outlet.
IMPORTANT: When moving the air purifier, always lift unit by the carrying handle
located at the back.
OPERATING THE AIR PURIFIER
1. “POWER/UV-C” BUTTON:
Press this button to turn on or switch off the unit and UV light.
2. “SPEED” BUTTON:
The fan speed of the unit can be adjusted while the unit is in operation (L/I M/II H/III).
Each time that you press this button, the speed is adjusted from Low (I) to Medium (II)
to High (III).
OPERATING INSTRUCTIONS
6
3. “TIMER” BUTTON:
1) By pressing this button, the purifier can be timed to operate for intervals of 2
hours, 4 hours and 8 hours, stopping automatically when the selected operating
time has elapsed.
2) Press this button to select the required operating time. An indicator light
automatically indicates the selected operating time.
3) To select the continuous operating mode, press the button repeatedly until there
are no more indicator lights lit up.
Important note: When the unit is not in use, switch it off and unplug it.
INSTALLING & REMOVING FILTERS
FILTER REPLACE INDICATOR
When the POWER light flashes continuously, the filter needs to be replaced.
Replace the filter according to the directions then hold the POWER/UV-C button for 5
seconds to restart the system. The light will stop flickering.
*Combination Filter will last approximately 6 months.
1. Open the front cover from the top.
2. Remove the combination filter by pulling the two strips.
3. Insert a new Combination Filter into the unit. Use the strips on the filter to
determine the correct installation direction.
4. Reattach the extra Pre-filter to the Combination Filter.
5. Reattach the front cover of the unit and securely latch it into place.
6. Press and hold the POWER/UV-C Button for 5 seconds to reset the Filter Change
Indicator.
7
The air purifier and the outer Pre-/Activated Carbon Filter attached to the HEPA Filter
should be cleaned at least once every month. More frequent cleaning may be required
depending on environmental conditions.
FILTERS
Clean with the brush attachment of your vacuum cleaner. This will remove lint and dirt.
Combination filter（Pre-filter + Carbon + HEPA）
NOTE:
- Only the Extra Pre-filter is washable. Make sure the pre-filter is dry before
attaching the pre-filter to the combination filter.
- The Combination Filter is one filter system. The multiple layers include the Pre-filter,
activated Carbon Filter and the HEPA Filter.
UV LAMP RPLACEMENT
1. Open the UV lamp cover by using a screwdriver.
2. Carefully remove the UV lamp from the holder and unplug the connector.
3. Connect the new UV lamp to the connector and carefully fit the lamp back into the
holder.
Note: Do not look at the UV lamp directly while it is on.
CLEANING & MAINTAINING
THE COMBINATION FILTER
8
MAINTENANCE
•
Use a clean, dry, soft cloth to wipe the external surface of the unit.
•
NOTE: Do NOT stick any foreign objects or your fingers inside the unit.
•
CAUTION: Do NOT use gasoline, benzene, thinner, or harsh cleaners when cleaning
the unit, as these will damage the product.
•
NEVER use alcohol or other solvents.
TROUBLESHOOTING GUIDE
Before carrying out any of the following service checks, unplug the unit from the
power outlet.
Insufficient air flow
Check that the filters are clean
Check for any obstructions in the air inlet and outlet
Unit will not start
Check the power supply and electric fuses.
Check that the Front Cover is latched firmly in place.
Check that the Filter is firmly in place.
Excessive noise
Check for any foreign objects touching the fan.
The filter may be clogged and need replacing.
The foam sealing gaskets may be installed
incorrectly.
Unit placed on an uneven surface.
9
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may
cause undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.
WARRANTY
Oregon Scientific comes with an industry-leading 1 Year Warranty that begins on the
date of purchase. The warranty applies to the whole unit including the components. It
does not apply to damage resulting from failure to follow the instructions, accidents,
abuse, alterations, or disassembly by unauthorized individuals.
CUSTOMER SUPPORT
Are you a happy customer? If you have product questions or concerns, don’t hesitate
to contact us directly at info@oregonscientific.com.
Oregon Scientific has an award-winning warranty, exchange and customer service
teams that guarantees hassle-free solutions to any issue you might have within 24
hours.
Loading...