3
4
Chapter 2
Chapter 2
Getting Started
Your Accelerator Next operates on 2 “AA” batteries (not included).
Battery Installation
1) Make sure the unit is turned off.
2) Using a small Phillip’s screwdriver unscrew the battery cover on the back of the unit.
Do not take the screw all the way out of the cover.
3) The cover should drop out if you hold the unit upside down.
If it does not, raise the battery cover with your fingernail and pull it out and up.
4) Insert the 2 “AA” batteries, taking careful note of the correct polarity.
5) Replace the cover and screw the screw back into place.
Caution
• Different types of batteries or new and used batteries are not to be mixed.
• Only use batteries of the same or equivalent type.
• Remove batteries from the unit if the unit is not going to be used for a long time.
• Remove all batteries when replacing.
• Do not dispose of batteries in fire.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
Cleaning and Maintenance
The unit should be regularly examined for damage to the enclosure and other parts. In the event of such
damage the unit must not be used until the damage has been repaired. Always disconnect the power supply
and/or remove the batteries before cleaning. Wipe the unit with a dry cloth.
• Do not get the unit wet.
• Do not dismantle the unit.
Auto-off
If there is no input on the unit for few minutes the unit will automatically say goodbye and turn itself off to
conserve power. When you are ready to start playing again just press the [On/Off] button to turn the unit
back on.
Blackout Screen orAbnormal Display
Reset the unit by removing the batteries before replacing them.
Starting the Accelerator Next
Turn on the Accelerator Next by pushing the [On/Off] button at the top right of the keyboard.
Remember to turn the unit off when you have finished by pushing the same button.
The Cursor Pad
The cursor pad is a four-way control button that works by pressing the top, bottom,
left side or right side of the pad. It is used during some activities for control and for submitting your answer.
The cursor pad has two cursor selection buttons underneath it.