Orderly Electronics CRT1721 User Manual

CRT721CW
FCC INFORMATION:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.These limits are designed to provide residential protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not Installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception. which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
z Reorient or relocate the receiving antenna. z Increase the separation between the equipment and receiver. z Connect the equipment into an outlet on the circuit different from that to which the receiver is
connected.
z Consult the dealer or an experienced radio/TV technician for help.
FCC WARNING:
The equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. Modifications not authorized by the manufacturer may void user’s authority to operate this device.
GENERAL WARNINGS:
1. Important Instructions:
z This product is suitable for 14 years old and above. Please read the instruction manual
before you play with this product.
2. Make sure the unit always within the Radio Frequency (and Wi-Fi if connected) control range. Otherwise, the unit will out of control and may crash.
3. Safety Instructions:
z Keep away from the objects and crowds.
¾ The unit is flying at high speed; keep it away from crowds, buildings, high voltage
wires, etc.
¾ Do not operate this unit in bad weather.
z Keep away from water and rain.
¾ The unit has electronic and mechanical parts which may be damaged by water
z Keep away from the working unit.
¾ The blades are turning in high speed, always keep away from it.
1
LOCATION OF CONTROLS:
Main Unit:
8
2
1
6
5
3
7
8
4
9
1. Blades
2. Battery Compartment
3. Power ON-OFF Switch
4. Installed Li-ion Rechargeable Battery
5. DC IN Jack
6. Camera
7. Connection Cable from Installed Battery
8. Wheels
9. Battery Door
2
1
Remote Control:
3
6
5
7
13
15
1
2
11
14
4
8
12
10
9
1. Power On-Off Button
2. Indicator
3. Left Joystick
4. Right Joystick
5. Headless Mode Button
6. Left Turn Trimmer
7. Right Turn Trimmer
8. Forward Trimmer
9. Backward Trimmer
10. Right Side Trimmer
11. Left Side Trimmer
12. OK (One Key Return) Button
13. Hi-Low Speed Selection Button
14. 3D Rolling Button
15. Battery Door (On the rear)
3
PREPARATIONS:
Battery Recharging:
The unit has DC 3.7V Li-ion rechargeable battery and already installed in the battery compartment. Recharge it before first time use or when it is drained as follows:
1. Connect the small plug from the supplied Connect Cable to the Battery Connection Cable.
2. Connect the full sized USB Plug from the Connection
Computer or USB Charger (Not included) as illustrated below:
Cable to the USB Port on Personal
ConnecttoPersonal
ComputerorUSBCharger
(ComputerandUSB
Chargernotincluded)
3. Charging will automatically start. The Red Charging Indicator inside the full size USB Plug will
illuminate. When finished charging, the indicator will turn off.
To replace the battery:
If you want replace the installed battery by other new battery (not included), replace it as below:
1. Loosen the screw on the battery door by supplied screwdriver as illustrated below:
2. Press the tab on the battery door then lift it up.
3. Replace the battery.
4. Close the battery door then tighten the screw.
4
+ 10 hidden pages