![](/html/7f/7fd5/7fd52a2d6b834a661fc390b90fc426464ccdeee460d35000ebe00628709bcc19/bg1.png)
Hingelock
Hingelock
TEE Deployer
TEE Deployer
Model 625
Model 625
Introduction
Hingelock deployer Model 625 was developed to
conduct electric field measurements for the Interactive
Measurements Payload for Shuttle (IMPS) program. This
motorized unit is capable of extending and retracting
a 1.12 inch (2.86 cm) diameter by 32.8 foot (10 meter)
long Tubular Extendible Element (TEE). The deployer
features electrical and mechanical stops at
full-extension and -retraction. A potentiometer, driven
by the moving element, provides a continuous
indication of deployed length. To ensure minimal
distortion due to thermal gradients in a space environment, material perforations and thermal control
coatings are applied on both the inside and outside TEE
surfaces. An optional motor driven TEE cut-off device
may be added to the configuration shown above. This
deployment mechanism is designed to meet the requirements of document MIL-A-083577 (USAF) General
Specification for Moving Mechanical Assemblies for
Space and Launch Vehicles. This unit can be deployed
or retracted in orbit.
Typical Technical Specifications:
Antenna Element
Deployed Length: Up to 32.8 ft
(10 meters)
Diameter: 1.12 in (2.86 cm)
Configuration: Hingelock
Material: Beryllium Copper
0.0045 in
(0.1143 mm) thick
Thermal Control Silver &
Coating: Perforations with
Kapton or Teflon
(if required)
Weight 31.43 gr/ft
(with coatings): (103.12 gr/m)
Height: 8.23 in (20.9 cm)
Length: 22 in (55.9 cm)
Width: 6.81 in (17.3 cm)
Total Unit Weight:* 15 lbs (6.7 kg)
Drive Motor: Brushless D.C.
Power: 14 Watts maximum
Voltage: 24-32 Vdc
Deployment Rate: Approximately
Operating
Temperature Range: -20°C to +70°C
*w/o TEE Cut-Off Device
Deployer
1.2 in/sec
(3 cm/sec)
![](/html/7f/7fd5/7fd52a2d6b834a661fc390b90fc426464ccdeee460d35000ebe00628709bcc19/bg2.png)
Features
■ Automatic full-extend and -retract motor power cut-off
■ Full-extend and -retract flags
■ Deployed length indicator
■ Minimal magnetic materials
■ Side mounting configuration is shown
■ Deployed TEE alignnment to within 0.1 degree
■ Optional TEE Cutoff device shown
3.06
5.38
6.00
5.5
6.25
10.125
6.81
5.13
2.63
All dimensions are in inches
unless otherwise noted
7.15
8.23
4.22
11.19
14.34
22.00
Hingelock TEE Deployer
Model 625
Orbital Technical Services Division
5010 Herzel Place
Beltsville, MD 20705
Phone: (301) 902-1152 FAX: (301) 931-0396
www.orbital.com
7500 Greenway Ctr. Dr.,
Ste. 700 Greenbelt, MD 20770
Phone: (301) 220-5600 FAX: (301) 474-2600