Part#: OVHP44
V-hepa Plus
www.sylvane.com 1-800-934-9194
Table of Contents:
Safety Instructions 1
Know Your Air Purifier 2
Functions 2
Electric User Interface 3
Assembly and Maintenance 3
Cleaning and Maintenance 3
How to Remove the Cover 4
How to replace the UV Lamp 4
Safety Instructions:
WARNING: RISK OF ELECTRICAL SHOCK
Safety precautions should always be used when operating this or
any electrical appliance.
Decrease the risk of electrocution, electric shock, injury or fire by
reading and following all of the warnings below.
To reduce the risk of electric shock, do not attempt to service the
air purifier in any way other than to replace or clean the air filter.
Read all instructions before operating the air purifier.
This product operates at 115V AC, 60Hz only.
Do not run the power cord under carpets, and do not cover with
throw rugs.
This product is not intended to filter oil or grease from air.
Always unplug the power cord from the electrical outlet when the
air purifier is not in use or when changing the filter.
Never run the air purifier unless it is fully assembled.
Do not alter the plug in any way.
Always turn the manual control knob to the off position before
unplugging the air purifier from outlet.
Do not place the cord near a heated surface.
Never operate the air purifier if the plug or cord is damaged or
appears
damaged. Only qualified service personnel should ever replace
or attempt to replace a damaged power cord.
Never use the power cord to pick up, carry, drag, pull, or lift the air
purifier. Do not pull the cord against or around sharp corners and
edges. Always remove the plug from its power outlet by holding
onto the plug itself
and pulling gently.
Never pull on the cord itself to unplug it from its power outlet.
Use care when operating the air purifier by keeping all foreign
objects, fingers, body parts, hair, loose clothing and jewelry away
from openings.
Never touch the air purifier or its plug when your hands are wet.
www.sylvane.com 1-800-934-9194
Know Your Air Purifier:
Functions:
1. Washable pre-filter to capture large particles such as dust.
2. HEPA filter to remove microscopic particles down to 0.3 microns
in size such as fine dust, smoke, pollen, bacteria and mold.
3. Low level and ozone safe negative ionizer to freshen and
balance the air(ie neutralize a surplus of positive charges from
Tv s and computer monitors).
4. Photocatalyst filter (TiO2): Photocatalytic oxidation is achieved
when you combine UV rays with a Titanium Dioxide (TiO2) coa
ted filter. This process creates hydroxyl radicals that remove
harmful gases and VOC s (volatile organic compounds) such as
formaldehyde, ammonia and many other common contaminants
that are released by building materials, household cleaners, particle
boards and carpeting.
5. UV-C lamp. Ultraviolet light possesses just the right amount of energy
to break organic molecular bonds. As microorganisms pass by the UV
rays this bond breakage translates into cellular or genetic damage to
microorganisms such as germs, viruses and mold resulting in their
destruction.
6 Three fan speed.
Assembly and Maintenance:
1.The washable pre-filter can be separated from the HEPA filter
and cleaned with water or a low level suction vacuum cleaner.
This is suggested every couple months if you have pet hair or
above average dust levels.
2.The HEPA filter cannot be washed and the media in the filter will
be damaged if it becomes wet.
3. If the air purifier begins to make a noise like the motor is straining
due to increased air flow resistance it is best to replace the HEPA
filter since the air flow through the air purifier is being greatly
reduced.
UV Lamp
Front case
Pre-filter+Hepa filter
Main unit
Ionizer
TiO2 filter
Electric User Interface:
S
p
e
e
d
2Hr
8Hr
4Hr
n
o
I
/
V
U
r
e
T
i
m
Power
1. Press center button to turn on/off air purifier.
2. Air purifier will start on the medium fan speed with the UV/ion on.
3. Pressing the speed button will cycle the fan to high speed(red) low speed(green) - medium speed(yellow)
4. Pressing the timer button will cycle between 2 Hours, 4 Hours,
and 8 Hours setting. Once the selected time has passed, the air
purifier will automatically turn off.
www.sylvane.com 1-800-934-9194
Pull back
Lift up
B.Push towards
the unit body
A. Insert base of
front cover
How to Remove the Cover:
1. Make sure the air purifier is turned off and unplugged.
2. Grab the cover near the top and pull toward you as shown below.
3.Clean or replace the filter. When placing the filter back into
the air purifier ensure the black pre-filter side is facing towards
you.
4.To re-install the front cover, place the bottom of the cover
into the slots at the base of the air purifier first and then pivot the
cover until the magnets near the top lock the cover in place.
How to replace the UV Lamp
1.Caution do not touch the glass part of the lamp. Oil from fingertips will
decrease the effectiveness of the lamp.
2.To remove the lamp, ensure the air purifier is unplugged and the UV
lamp has been off for at least 15 minutes. Remove the front cover and all
of the filters. Hold the white ceramic ends of the UV lamp and turn 90
degrees counter clockwise.
3.To install the lamp, hold the white ceramic ends, insert the copper pins
into the UV lamp assembly and turn 90 degrees clockwise. Reinstall the
filters and close the front cover.
www.sylvane.com 1-800-934-9194
Loading...