Page 1
Optoma
IEEE
WIRELESS DONGLE MODULE
ACWZZN, WUSB
802.11
b/g/n
QUICK START GUIDE
Version 1.1
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
1
Page 2
◆ Wireless LAN Adapter
◆ Quick Start Guide
1. BOX CONTENTS
◆ Driver CD
2. INSTALL DRIVER/UTILITY
Step 1 : (Win7/8/8.1/10 only)
Insert the installation CD into your
CD-ROM. Win7/8 UAC Dialog is shown.
Click Yes to continue.
Step 2 :
Wizard is ready to install driver and
utility. Click Next to begin the
installation
Step 3 :
Preparing Setup dialog is shown
2
Page 3
Installing & configuring WLAN driver and
utility
Installing Cisco 802.1x module
Step 4 :
Click Finish to complete installation. The
installation will affect after windows
rebooting
3
Page 4
General Specification
Model Name
ACWZZN, WUSB
Product Name
WIRELESS DONGLE MODULE
Standard
802.11b/g/n
Data Transfer Rate
1,2,5.5,6,11,12,18,22,24,30,36,48,54,60,90,120,180,240,270
and maximum of 300Mbps
Modulation Method
BPSK/ QPSK/ 16-QAM/ 64-QAM/ DBPSK/ DQPSK/ CCK
Frequency Band
2.4GHz ISM Band
Spread Spectrum
IEEE 802.11b: DSSS (Direct Sequence Spread Spectrum)
IEEE 802.11g/n:OFDM (Orthogonal Frequency Division
Multiplexing)
Operation Mode
Ad hoc, Infrastructure
Receiver Sensitivity
11Mbps -80dBm@8%, 54Mbps -70dBm@10%,
300Mbps -64dBm@10%
Operation Range
Indoor up to 100 meters, Outdoor up to 280 meters
LED
Power
OS Support
Windows 7/8.1/10,Mac OS,Linux
Security
64 bit/128 bit WEP, TKIP, AES, WPA, WPA2
Interface
USB 2.0
Power Consumption
DC 5V
Transmit: around 253 mA
Receive: around 162 mA
Transmit + Receive: around 274 mA
Operating Temperature
-10 – 60° C ambient temperature
Storage Temperature
-20 ~ 70°C ambient temperature
Humidity
5 to 90 % maximum (non-condensing)
Dimension
28.5x16x8mm (LxWxH)
Our products only suitable for projector application it improper be installed in other products and
it's not usual consumers can replace projectors by themselves.
4
Page 5
5
Page 6
6
Page 7
7
Page 8
8
Page 9
9
Page 10
10
Page 11
11
Page 12
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this
equipment.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
Note: The country code selection is for non-US model only and is not available
to all US model. Per FCC regulation, all WiFi product marketed in US must
fixed to US operation channels only.
12
Loading...