OptiPure SX2-22B User Manual
The SX2-22B
is a two housing water treatment system
ScaleX2
®
Snapshot
Foodservice Filtration Systems
with 20” drop-in cartridges that reduces sediment down
to 5 micron and reduces chlorine, taste & odor at a ow
rate of 4.0 gpm for 50,000 gallons. This system includes
ScaleX2®, a chemical-free scale prevention technology
that utilizes Template Induced Crystallization to effectively
inhibit the formation of calcium scale.
System Bene ts
Model: SX2-22B
Part #: 160-50143
ITEM #: __________________ QTY: ________
JOB NAME/NUMBER_____________________
l
, acheived a 99.6% effectiveness rating
when tested by an independent laboratory against the
international protocol for scale prevention.
l
Protects boilers, steam generators, and water heaters
against the formation and accumulation of scale.
l
Reduces maintenance frequency and cost, and extends
equipment life.
l
Gradient-density depth ltration reduces dirt, rust and
other debris as small as 5 micron to assure clean, clear
water and protect solenoids, valves and other ttings
against wear and plugging.
l
High capacity activated carbon ltration makes water taste
great and protects equipment against corrosive chlorine.
l
Sturdy mounting bracket and full- ow inlet shut-off valve
makes installation simple.
l
Built-in pressure gauge allows visual monitoring of
operating pressure.
l
Inlet shut-off and depressurization valve make changing
the lter quick and simple.
l
Generates less waste, only the drop-in lter is replaced.
No discarding of metal or plastic quick-change lters.
Application
STEAM & COMBI OVENS
to 4 gpm. Not recommended for ‘ ash’ type (boilerless) combi
ovens.
TANKLESS WATER HEATERS OR CONVENTIONAL
WATER HEATERS
-
boilers or steam generators up
- Up to 4 gpm owrate.
Installation Tips
l
Feed-water connection to system should be COLD only.
l
Do not exceed system speci cations for temperature
and pressure.
l
Allow 3” clearance below system for lter housing
removal and cartridge replacement.
l
Connect ltered water line to ice and steam production
connections only. Do not use for condenser water.
l
Detailed installation, operation & maintenance manual
is included with each system.
l
No activation procedure or ushing is required for
system to perform as speci ed.
Model: SX2-22B
Foodservice Filtration S y s t e m s
COMPONENT
Part #: 160-50143
Specications
System
Dimensions
(Height x Width X Depth, inches)
Connection - Inlet & Outlet 3/4” NPT female
Operating Pressure Range 10-125 psi
Inlet Water Temperature Range 35o -100
Shipping Weight 24 lbs.
Performance
Chlorine, Taste and Odor
Reduction Capacity at 3 gpm
Recommended Service Flow
Rate for Optimum Scale Inhibition
Sediment Reduction 5 micron
Scale Inhibitor ScaleX2
26” x 20” x 9”
(0.7 -8.6 bar)
o
F
o
(2o -38
C)
50,000 gals
(189,250 liters)
4.0 gpm
(15.2 lpm)
(nominal)
®
Dealer/Distributor Info:
The ScaleX2 element is tested
and certied by NSF International
against NSF/ANSI Standard 42 for
material requirements only.
Replacement Cartridge(s)
Model Part Number Qty
CTO-20B 252-20420 1
SCLX2-4 252-60220 1
SX22BRK* 252-60124 1
* Replacement cartridge kit includes one each of both cartridges.
It is recommended that lters be changed yearly, when
capacity is reached or when efuent pressure or ow
becomes inadequate.
This product is for commercial use only and must be
installed
and maintained according to manufacturers
guidelines.
Do not use on water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or
after the system.
Warranty
Systems have a 3 year warranty against defects in
material and workmanship. For complete warranty
information contact OptiPure customer service or go to
www.optipurewater.com.
OptiPure, Mfg. by Procam Controls, Inc.
2605 Technology Dr., Bldg 300
Plano, TX 75074
p: 972.881.9797; f: 972.422.6262
www.optipurewater.com
SX2-22Bspec109
Loading...