OptiPure FXI-22P User Manual

Model FXI-22P

Performance Data Sheet

Item# 160-50120

The OptiPure FXI-22P water treatment system is Tested and Certi ed by NSF International.

Functional Data

The contaminant reduction capabilities of the system’s combined water treatment technologies offer a wide range
of bene ts that include:

• Filters out dirt, sediment, rust and other particulate matter.

• Takes out disinfectant chlorine and the taste and odor associated with chlorine.

• Takes out offensive tastes and odors.

• Inhibits corrosion and the formation of scale (lime-scale/calcium carbonate).

Rated Capacity/Service Life: 60,000 gallons (227,100 liters)

Service Flow Rate: 6 gpm (22.7 lpm)

NSF/ANSI Certi ed Performance

This system has been tested according to NSF/ANSI 42 for reduction of the substances listed below. The
concentration of the indicated substances in water
than or equal to the permissible limit for water leaving the system, as speci ed in NSF/ANSI 42.

Average

Reduction Analysis

Chlorine 1.9 mg/l 0.06 mg/l 50% 96.8%

Taste & Odor – – – –

Particulate 0.5 to <1 um 3633333 244000 85% 93.2%

Challenge

entering the system was reduced to a concentration less

Average

Ef uent

Reduction

Requirement

Percent

Reduction

NOTE: Testing was performed under standard laboratory conditions, actual performance may vary. It is
recommended that you have your water supply tested to determine your actual water treatment requirements.

NSF’s Certification Program is accredited by the American National Standards Institute (ANSI) and
Standards Council of Canada (SCC) for the reduction of claims specified in this Performance Data Sheet.

Replacement Cartridge(s):

Quantitiy Cartridge Item #

2 CTOS-20 252-20220

System Tested and Certi ed by

NSF International against NSF / ANSI

Standard 42 for the reduction of:

Standard 42: AESTHETIC EFFECTS

Chlorine Reduction:

Capacity - 60,000 gallons (227,100 liters)

Taste and Odor Reduction

Particulate Reduction: Class I

Manufactured by FilterXpress div. of Procam Controls Inc. 2605 Technology Dr. Bldg. 300, Plano, TX 75074

[phone] Fax [phone] www. lterxpress.com

OptiPure Model FXI-22P – Performance Data Sheet

General Installation Requirements

• System Dimensions: 26.5” H x 12.5” W x 9.75” D (add a minimum 3” to height to allow for lter sump
removal and cartridge replacement). Shipping weight is 24 lbs.

• System includes inlet shut-off valve / inlet & outlet are ” NPTF (female).

• System feed must be cold water only.

• Flush the system for 2 minutes to allow air and any carbon nes to escape. NO ACTIVATION PROCESS OR
EXTENDED FLUSHING IS REQUIRED FOR OPTIPURE SYSTEMS TO PERFORM AS CERTIFIED.

• Check operating requirements of equipment serviced before shutting off water supply.

• System operating range: Pressure: 10-125 psi (0.7-8.6 bar) Temperature: 10-100°F (2 – 38°C)

•

This product is for commercial use only and must be installed and maintained according to manufacturers

guidelines.

• Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection
before or after the system.

General Operation & Maintenance Requirements

• System will deliver measurable performance for up to six months between lter changes when installed
according to application guidelines. Change lters every six months, when capacity is reached or when
efuent ow becomes inadequate.

• Replacement lter perfromance is assured without activation or extended ushing.

• Check operating requirements of equipment serviced before shutting off water supply.

• Installation and operation & maintenance manuals are provided with the system and include
parts and service availability.

Warranty Information

OptiPure systems carry a three year limited warranty for defects in materials and workmanship when installed
and maintained in accordance with manufacturers recommended procedures and guidelines. For complete
warrany information refer to the warranty statement included with each system or contact FilterXpress.

NOTE: The FXI-22P utilizes IsoNet™ (patent pending) to provide protection against corrosion and the

formation & build-up of calcium (lime-scale) on equipment surfaces. Scale and corrosion inhibition is not
tested and certied by NSF.

PDS03-FXI22P