OptiPure FXAF-12 User Manual
The FXAF-12
is a single housing water treatment system
Snapshot
Foodservice Filtration Systems
with a drop-in 2.5” x 20” cartridge that takes out dirt, rust
and other particulates down to 5 micron. The system
can be used as a point-of-use sediment reduction lter;
or it can be applied prior to a primary ltration system to
provide additional pre ltration to protect against premature
plugging due to excessive dirt and sediment levels found
in some water supplies.
System Bene ts
Model: FXAF-12
Part #: 160-50305
ITEM #: __________________ QTY: ________
JOB NAME/NUMBER_____________________
l
system.
l
PolyTrix® gradient-density depth ltration reduces dirt, rust,
and other debris as small as 5 micron to assure clean,
clear water and protect solenoids, valves and other
ttings against wear and plugging.
l
Protecting down-line ltration systems against premature
plugging reduces lter change frequency and associated
cost.
l
Sturdy mounting bracket and full- ow inlet shut-off valve
makes installation simple.
l
Built-in inlet shut-off and depressurization valves make
changing the lter quick and simple.
l
Generates less waste, only the drop-in cartridge is
replaced. No discarding of metal or plastic quick-change
lters.
l
Built-in pressure gauge allows visual monitoring of
operating pressure.
Application
ALL EQUIPMENT APPLICATIONS - When excessive
sediment is a problem.
EXISTING FILTRATON SYSTEMS - Provides added
pre ltration to extend lter life.
Installation Tips
l
Feed-water connection to system should be COLD only.
l
Do not exceed system speci cations for temperature
and pressure.
l
Allow 3” clearance below system for lter housing
removal and cartridge replacement.
l
Detailed installation, operation & maintenance manual
is included with each system.
l
No activation procedure or ushing is required for
system to perform as speci ed.
Model: FXAF-12
Foodservice Filtration S y s t e m s
Part #: 160-50305
Specications
System
Dimensions
Height x Width X Depth, inches
Connection - Inlet & Outlet 1/2” NPT female
Operating Pressure Range 10-125 psi
Inlet Water Temperature Range 35o -100
Shipping Weight 10 lbs.
Performance
Chlorine, Taste and Odor
Reduction Capacity
Service Flow Rate 5 gpm
Sediment Reduction 5 micron
Scale & Corrosion Inhibitor N/A
24 1/2” x 6 9/16”
x 5 1/8”
(0.7 -8.6 bar)
o
F
o
(2o -38
C)
N/A
(19 lpm)
(nominal)
Dealer/Distributor Info:
Replacement Cartridge(s)
Model Part Number Qty
S5-20 252-10120 1
It is recommended that lters be changed every six
months, when capacity is reached or when efuent
pressure or ow becomes inadequate.
This product is for commercial use only and must be
installed
and maintained according to manufacturers
guidelines.
Do not use on water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or
after the system.
Warranty
Systems have a 3 year warranty against defects in
material and workmanship. For complete warranty
information contact OptiPure customer service or go to
www.optipurewater.com.
OptiPure, Mfg. by Procam Controls, Inc.
2605 Technology Dr., Bldg 300
Plano, TX 75074
p: 972.881.9797; f: 972.422.6262
www.optipurewater.com
FXAF-12spec109
Loading...