Page 1
The QT10-2 is a two cartridge water treatment system with
Snapshot
Foodservice Filtration Systems
parallel-plumbed 10” Quik-Twist cartridges that reduces
sediment down to 0.5 micron and reduces chlorine, taste &
odor at a ow rate of 3 gpm for 30,000 gallons.
System Bene ts
Model: QT10-2
Part #: 160-52019
ITEM #: __________________ QTY: ________
JOB NAME/NUMBER_____________________
l
Provides ‘primary’ ltration for combination applications
including cold and hot bevarages and ice makers.
l
Reduces maintenance frequency and cost, and extends
equipment life.
l
Gradient-density depth ltration reduces dirt, rust, and
other debris as small as 1/2 micron to assure clean,
clear water and protect solenoids, valves and other
ttings against wear and plugging.
l
High capacity activated carbon ltration makes water
taste great and protects equipment against corrosive
chlorine.
l
Reduced sediment, chlorine and taste & odor can improve
beverage ingredient ef ciency.
l
Mounting bracket and full- ow inlet shut-off valve makes
installation simple.
l
1/4 turn QT ‘Quik-Twist’ bayonet cartridges make
changing the lters quick, easy and sanitary.
l
NSF Certi ed under Standard 42.
Application
FOUNTAIN BEVERAGES - Up to 100 bag-in-box per
month / single carbonator.
COMBINATION APPLICATIONS - Provides primary
ltration for multiple points-of-use.
Installation Tips
l
Feed-water connection to system should be COLD only.
l
Do not exceed system speci cations for temperature
and pressure.
l
Allow 3” clearance below system for lter housing
removal and cartridge replacement.
l
Detailed installation, operation & maintenance manual
is included with each system.
l
No activation procedure or ushing is required for
system to perform as speci ed.
Page 2
Model: QT10-2
Foodservice Filtration S y s t e m s
Part #: 160-52019
Specications
System
Dimensions
(Height x Width X Depth, inches
Connection - Inlet & Outlet 3/8” NFPT
Operating Pressure Range 10-125 psi
Inlet Water Temperature Range 35o -100
Shipping Weight 7 lbs.
Performance
Chlorine, Taste and Odor
Reduction Capacity
Service Flow Rate 3.0 gpm
Sediment Reduction .5 micron
Scale & Corrosion Inhibitor NA
16.1 x 10 x 7”
(0.7 -8.6 bar)
o
o
(2o -38
C)
30,000 gals.
(113,550 liters)
(11.4 lpm)
(nominal)
F
Model QT10-2 is tested and certied by
NSF International against NSF/ANSI
Standard 42 for the reduction of:
Standard 42: Aesthetic Effects,
Chlorine Reduction
Taste and Odor Reduction
Nominal Particulate Reduction, Class 1
Dealer/Distributor Info:
Replacement Cartridge(s)
Model Part Number Qty
CTO-Q10 300-05828 2
It is recommended that lters be changed every six
months, when capacity is reached or when efuent
pressure or ow becomes inadequate.
This product is for commercial use only and must be
installed
and maintained according to manufacturers
guidelines.
Do not use on water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or
after the system.
Warranty
Systems have a 3 year warranty against defects in
material and workmanship. For complete warranty
information contact OptiPure customer service or go to
www.optipurewater.com for a copy of the warranty.
OptiPure, Mfg. by Procam Controls, Inc.
2605 Technology Dr., Bldg 300
Plano, TX 75074
p: 972.881.9797; f: 972.422.6262
www.optipurewater.com
QT10-2spec109
Loading...