Page 1
g
g
g
12-171 7.fm Page 1 Monda y, July 12, 1999 9:26 A M
Three-Way FlushMount Car Speakers
Your Optimus Three-Way FlushMount Car Speakers provide clean
sound and each speaker can handle
up to 30 watts. The panel-mount design lets you easily mount the speakers so that they are flush with the
mounting surface. To get the best
sound from your speakers, read this
entire manual carefully for the proper
wiring and mounting procedure.
BEFORE YOU BEGIN
We recommend that you wire the
speakers to your sound system before
you mount the speakers so that you
can test the speakers and the wire
connections. Then, disconnect the
wires, route the wires, and m ount the
speakers.
If you are unsure about wiring
Note:
or mounting, we suggest you have a
professional install the speakers.
Cat. No.
12-1717
WIRING THE
SPEAKERS
All RadioShack autosound systems
come with four color coded speaker
wires. The following chart shows RadioShack’s standard color codes.
Speaker Terminal Wire Color
Left Positive (+) Green
Left Ne
Ri
Ri
Connect your stereo’s speaker wires
to the speakers, using the color-code
chart as a guide. Then, turn on your
stereo to be sure that you properly
connected the speakers.
Note:
also equipped with f our wires but the
wires might not use the same color
codes. If your autosound system is a
brand other than Radio Shack, check
the owner’s manual for the speaker
wire color codes.
ative (–) White
ht Positive (+) Brown
ht Negative (–) Gray
Other autosound systems are
Caution:
speaker wires to the chassis ground.
Use all four wires to connect the
speakers to your veh icle’s auto sound
system.
© 1997 Tandy Corporation.
Optimus and RadioShack are registered trademarks used by Tandy Corporation.
All Rights Reserved.
Do not connect any o f your
Page 2
12-171 7.fm Page 2 Monda y, July 12, 1999 9:26 A M
Two-Speaker System
Four-Speaker System
Notes:
• Be sure you match the speaker
wires to their corresponding positive (+) or negative (–) speaker
terminals to ensure proper phasing. Improper phasing can cause
poor bass response.
• If your speaker system includes
rear speakers, the same color
code applies. If your auto sound
system has a front to rear fader,
connect your speakers as follows:
MOUNTING THE
SPEAKERS
Follow these steps to mount the
speakers.
1. Remove the door panel you want
to mount the speaker on and find
a location where the speaker will
fit. Most vehicles hav e a prepared
cut-out area in the door for
speaker placement. Use the supplied template to be sure the location you choose is large enough
for the speaker opening.
To be sure the speaker will
Note:
not interfere with your vehicle’s
window mechanism, roll down
your vehicle’s window completely.
If the window has a hand crank,
be sure the speaker will not hinder
you from turning the crank.
2. Mark the mou nting hole locations
and outline the speaker on the
door panel using the supplied
template.
2
Page 3
12-171 7.fm Page 3 Monda y, July 12, 1999 9:26 A M
3. Drill a starter ho le inside the outlined area. Carefully remove the
area you marked, using a razor,
tin snip, or a hacksaw blade.
4. Drill three
1
/8-inch mounting holes.
5. Disconnect the wires from the
speakers and route them from
your sound system through the
door sill and to the speaker’s
mounting location. You might
need to drill a hole to route the
wire through the door sill. Some
cars have predrilled holes and
rubber tubes for routing wires.
Cautions:
• Be sure you allow enough slack
in the wire to prevent pulling the
wire front he speaker when you
open the door all the way.
6. Replace the door panel. Then,
pull the wires through the hole you
made for the speaker and connect
the wires to the speaker’s terminals. See “Wiring the Speakers.”
7. Mount the speaker as needed.
• If you mount the speaker on a
metal surface, align the moun ting holes on the speaker with
the three drilled holes and
secure the speaker with the
supplied screws.
• If you mount the speaker on a
non-metal surface, insert the
three supplied speed clips into
the mounting ho les to ensure a
firm mount and to protect the
mounting holes. Then align the
mounting holes o n the speaker
with the three drilled holes and
secure the speaker with the
supplied screws.
8. Align the speaker grille with the
speaker and press it onto the
speaker until it snaps into place.
• Tape any exposed wire to prevent the wire from being
pinched or cut when the door is
closed.
3
Page 4
12-171 7.fm Page 4 Monda y, July 12, 1999 9:26 A M
SPECIFICATIONS
Woofer ........................................................................................................ 51/4 Inch
Midrange ........................................................................................................ 2 Inch
Piezo Tweeter ................................................................................................ 1 Inch
Magnet Weight............................................................................17.72 oz (502.65 g)
Power-Handling Capability ............................................................... 30 Watts Each
Impedance .................................................................................................. 4 Ohms
Frequency Response .................................................................. 70 Hz–20,000 Hz
Sensitivity .................................................................................. 90 dB 1 Watt 50cm
Specifications are ty pical; individual units might v ary. Specifications are subject to
change and improvement without notice.
Limited Ninety-Day Warranty
This product is warranted by RadioShack against manufacturing def ects in material and work manship under normal use
for ninety (90) days from the date of purchase from RadioShack company-owned stores and authorized RadioShack franchisees and dealers. EXCEPT AS PROVIDED HEREIN, RadioShack MAKES NO EXPRESS WARRANTIES AND ANY
IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE,
ARE LIMITED IN DURATION TO THE DURATION OF THE WRITTEN LIMITED WARRANTIES CONTAINED HEREIN.
EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABILITY OR RESPONSIBILITY TO CUSTOMER OR
ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR
INDIRECTLY BY USE OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE, LOSS OF TIME,
DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow the limitations on how long an implied warranty lasts or the exclusion of incidental or consequential damages, so the above limitations or exclusions may not apply to you.
In the event of a product defect during the warranty period, take the product and the RadioShack sales receipt as proof of
purchase date to any RadioShack store. RadioShack will, at it s option, unless otherwise provided by law: (a) correct the
defect by product repair without charge for parts and labor; (b) replace the product with one of the same or similar design;
or (c) refund the purchase price. All replaced parts and products, and products on which a refund is made, become the
property of RadioShack. New or reconditioned parts and products may be used in the performance of warranty service.
Repaired or replaced parts and products are warranted for the remainder of the original warranty period. You will be
charged for repair or replacement of the product made after the expiration of the warranty period.
This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse, accident, misuse, improper or abnormal usage, failure to follow instructions, improper installation or maintenance, alteration, lightning or other
incidence of excess voltage or current; (b) any repairs other than those provided by a RadioShack Authorized Service Facility; (c) consumables such as fuses or batteries; (d) cosmetic damage; (e) transportation, shipping or insurance costs; or
(f) costs of product removal, installation, set-up service adjustment or reinstallation.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
RadioShack Customer Relations, Dept. W, 100 Throckmorton St., Suite 600, Fort Worth, TX 76102
We Service What We Sell
3/97
RadioShack
A Division of Tandy Corporation
Fort Worth, Texas 76102
9A7 Printed in China
Loading...