V-LINE BACK
INSTALLATION INSTRUCTIONS
SUGGESTED USE
V-line series is the Stand anti-theft protection dedicated to
smartphones and tablets.
The aesthetic product presentation is allowed by two types of
sensors: angled (25°) and flat.
An additional advantage is the possibility of rotation of the sensor by
90°, which allows convenient testing of the product.
Small size assured optimum visibility of the product.
The image below shows the components needed to assemble the
whole system.
1) Stand V-line Back + V-line Back sensor
2) charging cable
3) cleaning tissue with izopropylan
4) USB 5V/2A power supply
5) smartphone
Cleaning tissue with izopropylan assures the proper preparation
of the surface under Optiguard stickers.
WARNING!
After connecting the device to a charger, a periodically blinking yellow diode in the base indicates lack of any programmed remote controls.
Optiguard sp. z o.o.
ul. Aleksandrowska 6-10, 87-100 Toruń
NIP 956-213-03-91
Phone +48 56 654 71 33 1 / 5
SERIES V-LINE
Using the cleaning tissue with izopropylan, we can prepare the
surface of the furniture, to which Stand V-line will be attached.
After cleaning the furniture, wait until the cleaning substance
evaporates.
Take off the protective papers from the stickers.
Place the cable (with USB connector) in a special groove located
in the housing of Stand V-line.
Stick Stand to the furniture and press for approx.
10 seconds for good bonding of the sticker adhesive.
INSTALLATION INSTRUCTIONS
Optiguard sp. z o.o.
ul. Aleksandrowska 6-10, 87-100 Toruń
NIP 956-213-03-91
Phone +48 56 654 71 33 2 / 5
SERIES V-LINE
Using the cleaning tissue with izopropylan, we can prepare the
surface of the mobile, to which the sensor will be attached. After
cleaning, wait until the cleaning substance evaporates.
Take off the protective paper from the sticker of V-line sensor.
Stick the phone to the sensor and press for approx. 10 seconds
for good bonding of the sticker adhesive.
The charging cable allows to connect the protective sensor.
The smartphone will be simultaneously charged and protected.
INSTALLATION INSTRUCTIONS
Optiguard sp. z o.o.
ul. Aleksandrowska 6-10, 87-100 Toruń
NIP 956-213-03-91
Phone +48 56 654 71 33 3 / 5
SERIES V-LINE
Plug the end of the cable with the sticker of "ALARM" in USB of
the smartphone.
Plug the other end of the cable in microUSB of V-line sensor.
USB 5V/2A charger provides adequate power for Stand
V-line and allows to charge the protected product.
Plug the cable from Stand V-line with USB connector in the
charger with USB port.
INSTALLATION INSTRUCTIONS
Optiguard sp. z o.o.
ul. Aleksandrowska 6-10, 87-100 Toruń
NIP 956-213-03-91
Phone +48 56 654 71 33 4 / 5
SERIES V-LINE
Plug USB charger with connected Stand V-line into a power
outlet (AC 230V).
Powered V-line will activate within 3 seconds. Short acoustic
signal and periodically blinking red LEDs in the sensor confirm
activation of the system. Finished!
INSTALLATION INSTRUCTIONS
Optiguard sp. z o.o.
ul. Aleksandrowska 6-10, 87-100 Toruń
NIP 956-213-03-91
Phone +48 56 654 71 33 5 / 5
Loading...