INSTALLATION INSTRUCTIONS
SUGGESTED USE
Stand S is a standalone anti-theft protection dedicated to
smartphones and tablets.
UMH3, UMH4 and DFO2 sensors allow aesthetic product
presentation.
Small size assures optimal visibility of the product.
The image below shows the components needed to assemble the
whole system.
1) Stand S + DC extension
2) power supply 19V/3.42A
3) charging cable
4) cleaning tissue with isopropoxide
5) smartphone
Cleaning tissue with isopropoxide assures proper preparation of
the surface for Optiguard stickers.
WARNING!
After connecting the device to a charger, a periodically blinking yellow diode in the base indicates lack of any programmed remote controls.
STAND S
Optiguard sp. z o.o.
ul. Aleksandrowska 6-10, 87-100 Toruń
NIP 956-213-03-91
Phone +48 56 654 71 33 1 / 5
INSTALLATION INSTRUCTIONS
Through using the cleaning tissue with isopropoxide we can
prepare the surface of the furniture which Stand S will be
attached to. After cleaning the furniture wait until the cleaning
substance evaporates.
Take off the protective papers from the stickers.
Plug the DC extension connector to the DC port. Place the cable
inside the special groove underneath the base of the Stand S.
Stick Stand S to the furniture and press for approx.
10 seconds for good bonding of the sticker adhesive.
STAND S
Optiguard sp. z o.o.
ul. Aleksandrowska 6-10, 87-100 Toruń
NIP 956-213-03-91
Phone +48 56 654 71 33 2 / 5
INSTALLATION INSTRUCTIONS
Through using the cleaning tissue with isopropoxide we can
prepare the surface of the device which sensor will be attached
to. After cleaning the device wait until the cleaning substance
evaporates.
Take off the protective paper from the sticker of the UMH3
Stick the phone to the sensor and press for approx. 10 seconds
for good bonding of the sticker adhesive.
The charging cable allows connecting the protective sensor.
The smartphone will be simultaneously charged and protected.
STAND S
Optiguard sp. z o.o.
ul. Aleksandrowska 6-10, 87-100 Toruń
NIP 956-213-03-91
Phone +48 56 654 71 33 3 / 5
INSTALLATION INSTRUCTIONS
Plug one end of the charging cable which says "ALARM" into the
microUSB port of the smartphone.
Plug the other end of the charging cable into the microUSB port
of the UMH3 sensor.
19V/3.42A power supply provides enough power for Stand S and
allows charging the protected product.
STAND S
Connect the power supply connector to the DC extension cable.
Optiguard sp. z o.o.
ul. Aleksandrowska 6-10, 87-100 Toruń
NIP 956-213-03-91
Phone +48 56 654 71 33 4 / 5
INSTALLATION INSTRUCTIONS
Plug the power supply with the Stand S connected to it into the
electrical outlet (AC 230V).
Powered Stand S will be activated within 3 seconds. Short
acoustic signal and periodically blinking red LEDs in the sensor
confirm activation of the system. Finished!
STAND S
Optiguard sp. z o.o.
ul. Aleksandrowska 6-10, 87-100 Toruń
NIP 956-213-03-91
Phone +48 56 654 71 33 5 / 5
Loading...