opticis OMVC-200, DirekTronik 25-0580 - OMVC-200 User Manual

© 2012 Opticis Co., Ltd. All Rights Reserved
Revision 1.0. 29, May, 2012

User’s Manual

Multi-format to

1-fiber DVI converter,

OMVC-200

www.opticis.com

Manual Contents

__________________________________________

Manual Contents 1-0
Welcome! Product Description 1-1
System Requirements for Setup 1-2
Installation 1-3
Self-EDID Programming Procedure 1-5
Troubleshooting, Maintenance, Technical Support 1-6
Product Specifications 1-7
Warranty Information 1-8
Regulatory Statements 1-9

Pictorials

Figure 1 – Connection Diagram of OMVC-200 1-4

1- 0 Manual Contents

Regulatory Statements

This device complies with part 15 of FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation. This equipment has been
tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 and 2 of FCC Rules, EN 55022/55024/61000-3 for CE
certification. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and. if not installed and used in accordance with the instruction guide,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:

 Re-orient or relocate the receiving antenna.
 Increase the separation between the equipment and the

receiver.

 Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

 Consult a service representative for help.

Properly shielded and grounded cables and connectors must be used in order
to comply with FCC/CE emission limits. Changes or modifications not
expressly approved by the party responsible for compliance could void the
user s authority to operate the equipment.

1-9 Regulatory Statements