Optibike Pioneer Allroad Quick Start Manual

This is the Quick Start Guide for the Optibike
Pioneer Allroad electric bicycle. The Guide provides
for basic information required to ride the Allroad. It
is not intended to be an extensive manual. It is

recommended that you always ride your Allroad with

a helmet and observe all traffic regulations.

 The Pioneer Allroad is considered an electric bicycle

by Federal Guidelines.

 It can be operated where electric bicycles are legal.

 Laws for electric bicycles vary by town and state.
 Generally, electric bicycles are allowed on all bicycle

lanes on streets.

 Their use on dedicated bike paths or off road trials

varies.

 Consult your local municipality for their regulations.
 In general electric bicycles are subject to the same

regulations as regular bicycles.

 If you plan to ride at night, a headlight and taillight

are required and should be purchased at your local
bicycle shop.

 Electric bikes travel faster than conventional

bikes.

 Car drivers may think you are going slower than

you are and pull out in front of you.

 This may happen when they pull out from a side

street or have just passed you and turning right.

 Use Hand Signals

 Be Aware!

 Be Courteous to pedestrians and other cyclists.

 The following riding gear is recommended:

◦ Properly fitted helmet

◦ Bicycle Gloves

◦ Eye Protection
◦ Bright Clothing

 In areas with rapidly changing weather

conditions, be sure to bring extra clothing.

 It is highly recommended that you carry a spare

inner tube, basic tool kit, and tire pump when
you ride.

 A water bottle for hydration is also a good idea.
 Use Sun Screen if riding in sunny areas.

 Check the tires for proper inflation

and wear (35 psi is a good pressure)

 Be sure the brakes are in good

working order and adjusted

 Make sure the chain is lubricated

 Have the battery charged

 Check the throttle for free operation,

prior to turning on the bike.

 The seat should be adjusted for each rider. It

is easily adjusted be rotating the lever on the
seat clamp. Adjust the seat to your desired

height and then retighten clamp.

 Place the battery in

the frame mount.

 Turn the green switch

on the right lower side

of the battery to “1”.

 Hold down the “MENU”

button on the keypad

until the display turns
on.