Redwall Wire-Free
WF-100DT Digital Transmitter
User Guide
© Optex (Europe) Ltd. 2007
Every effort has been made to ensure that the contents of this book are correct. However,
neither the authors nor Optex (Europe) Ltd accept any liability for loss or damage caused
or alleged to be caused directly or indirectly by this book. The contents of this book are
subject to change without notice.
Printed and published in the U.K.
1. INSTALLATION
The WF-100DT Digital Transmitter should be programmed to the WF-100CU Control Unit
before commencing the installation. Refer to the Redw all Wire-Free ‘Installation &
Programming Guide’ supplied with the WF-100CU Control Unit.
2. TECHNICAL SPECIFICATION
Radio Section Operating frequency 868.6625MHz at 20KHz bandwidth.
Power Requirements 2 x Duracell MN1300 (not supplied). Typically two year battery life.
Radio Signalling Alarm, tamper, supervision and low battery.
Environmental Class IV Outdoor – General.
Ingress Protection IP64.
Dimensions 122 x 120 x 85 mm. H x W x D.
Weight 475g.
Issue 1 - 1 - 400001
3. TECHNICAL SUPPORT
Website: www.optex-europe.com
Email: tech-support@optex-europe.com
Phone: 01628 631 000
4. EC DECLARATION OF CONFORMITY
We,
Optex (Europe) Ltd
Platinum House
32B Clivemont Road
Cordwallis Industrial Estate
Maidenhead
Berkshire
SL6 7BZ
Declare that the following product:
WF-100DT
Complies with the following European Directives:
1995/5/EC R&TTE
89/336/EEC EMC
In accordance with the following harmonised standards:
EN 300 220-3
EN 301 489 1&3
EN 50131-1
EN 50131-5-3
EN 60950
A signed copy of this Declaration of Conformity can be found on our website:
www.optex-europe.com
Issue 1 - 2 - 400001
Loading...