OVS-01CC Quick Reference Guide
Calibration
1. Install the pole for the sensor in the following layout configuration.
Installation height: 500mm(19.69in.) from the ground to the bottom of the sensor
Installation angle: 90 degrees to the vehicle direction of travel.
Vehicle Path
90°
Sensor
Two way traffic lane : Install the sensor on the the lane of traffic you wish to monitor.
The sensor cannot detect a vehicle in the opposite lane.
Road not to
be detected
Road not to
be detected
500mm(19.69in.)
[4] Fix the base using 4 screws.
[6] Attach the sensor body to the base
and adjust the sensor angle.
[5] Connect wires.
Power Output1 Output2
Applicable Wire
Single conductor: 0.5-1.2mm (equivalent to CPEV)
Stranded wire: 0.3-2.0sq
Non-Voltage Relay Output N.O./N.C. Switchable
30VDC 0.3A or less (resistance load)
Non-Voltage Relay Output N.O./N.C. Switchable
30VDC 0.3A or less (resistance load)
Power Supply 12-24VDC
3.
Set the Microwave maximum range.
Recommended to set the range 1m(3.28ft.) shorter than the
actual width of the road.
Maximum Range (m)
Output1
1 2 3 4
5 6 7 8
Output2
N.O.
N.C.
N.O.
N.C.
Maximum Range Botton
Road to
be detected
2. Install the sensor, wire it and apply power.
[1] Make holes to mount the sensor.
5(0.20)
Depending on the
cable diameter
M4 Tap
Mounting
GL+588(23.15)
Pitch 32±1
(1.26±0.04)
[Unit : mm(inch)]
[2] Run a cable thru the post or pole.
Mounting Pitch
70±1(2.76±0.04)
Road to
be detected
Hold here and
pull forward
[3] Loosen the retaining screws on the bottom
of the front cover and remove the front
cover, detach the sensor unit.
4. Perform calibration in order to memorize the
5. System operation check.
background of the detection area. Ensure no
pedestrians or vehicles are present.
Standby
Area Check
Detection
Calibration
Calibration Area Check
1. Press the Calibration button.
2. Operation indicator blinks in blue.
3. Step away from sensor and
outside detection area.
4. Green LED lights when done
correctly.
6. Put the front cover on the top of the base first, and attach it
while spreading it open and pushing down the front cover.
Check the entire coverage area by using actual vehicle.
Left side of the lane
Center of the lane
Right side of the lane
Sensor
7. Tighten the front cover retaining screw.
Please read
IMPORTANT!
Loading...