OPTEK OVPL5W3K Technical data

Power Line Designer Kit

0.5-Watt LED Modules

OVPL5W3K

Contents:

x Five (5) PCBs 8” in length
x Populated with three (3) 0.5-Watt white LEDs
x Wire harness with connector
x Hand insertion tool

The self-contained Power Line Designer Kit is a flexible and scalable lighting solution using mid-power LEDs to
supply high luminous flux without additional heatsinking requirements. The kit includes components and
instructions to allow a designer to configure LED placement as needed for uniform illumination in his application.
With a 15-volt power supply, the Power Line Kit is a total lighting solution.

Applications

x Architectural accent lighting
x Under-counter lighting
x Media illumination
x Lighting for large channel letters
x Backlighting for light boxes
x Point-of-sale displays

PCB with 3LEDs

Optek Part No.

OPA773

1 board

2 boards
3 boards
4 boards
5 boards

Product Photo Here

Viewing

Angle

120°

Typical

CCT

White

5750K

*125mA per board stabilized

Typical Luminous

Flux (lm) @ 15V*

50
100
150
200
250

5 PCBs 8” x 7/16” wide

(.062 FR4 material)

RoHS

OPTEK reserves the right to make changes at any time in order to improve design and to supply the best product possible.

OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006
Phone: [phone] or [phone] FAX: [phone] [e-mail] www.optekinc.com

9” by 1”Ø tube

4’ Wire harness
with connector

Hand Insertion Tool

(AVX #9175)

DO NOT LOOK DIRECTLY

AT LED WITH UNSHIELDED

EYES OR DAMAGE TO

RETINA MAY OCCUR.

Issue A.2 05/08

Page 1 of 2

Power Line Designer Kit

OVPL5W3K

Package Dimensions

8 in

[203 mm]

OPA773

3 in

[76.2 mm]

3 in

[76.2 mm]

Individual board assembly available (Optek Part No. OPA773 Series)

Instructions

1. Determine position of boards

2. Peel tape backing from boards

3. Apply boards to backplane

4. Route wire harness to each board and use tool
to hand insert red and black wires on each
board. Start with loose end and work toward
connector.

5. Plug connector into 15V supply (1.0A minimum)

6. Place graphics over backplane about 2” from
LED assembly.

OPA773

.44 in

[11.1 mm]

Notes:

x All electrical and optical characteristics of the LEDs remain the

same as specified in Optek Datasheet OVS5WBCR4.

x Maximum storage and operating temperature –40° ~ +100°C
x ESD threshold (HBM) 2000V

OPTEK reserves the right to make changes at any time in order to improve design and to supply the best product possible.

OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006
Phone: [phone] or [phone] FAX: [phone] [e-mail] www.optekinc.com

Connector

Output connector

2.5mm ID/5.5mm OD

15V Plug

RED +
BLACK -

Issue A.2 05/08

Page 2 of 2