![](/html/a9/a9a7/a9a72aca21618a9829c1a3a6aa25592f6063bd4c3827b9294fe8bbac24deef82/bg1.png)
304 Andrea Dr. • Belgrade, MT 59714 • USA
800-251-7815 • info@optechusa.com
www.optechusa.com
TRIPLE CARRIER
™
Instructions & Care
Thank you for purchasing the OP/TECH USA TRIPLE CARRIER™. It can be congured to carry one, two, or three different
pieces of gear, from cameras to binoculars. You can even carry your tripod wIth the addition of a set of OP/TECH USA
SYSTEM CONNECTORS™-TRIPOD LOOPS (sold separately).
The TRIPLE CARRIER™ consists of the
following components:
A - a neoprene yoke with internal comfortstretch elastic and a non-skid surface backing
B - six (6) Uni-Loop Connectors, three (3) male
and three (3) female
C - two (2) webbing slings for use on both sides
of the TRIPLE CARRIER
D - a pair of center straps
E - a pair of 3/4" wide Torso Straps for added
stabilization
adjustable from 26" - 57" (66 - 144,8 cm)
F - a 3/8" wide Under-Arm Retaining Strap
adjustable from 12-21" (30,5 - 53,3 cm)
Please note that all these parts come preassembled except for the under arm retaining
strap.
™
A
D
B
C
E
F
1. Attach the male Uni-Loop connectors to the
right-hand sides of your cameras or binoculars.
The female Uni-Loops attach to the left-hand sides of
your gear. (Most cameras will only need to engage one
Uni-Loop connector when used on a sling.)
2. Attach the Uni-Loop connectors to the mating quick
disconnects. A camera carried on the right side sling
will most often only need to be connected via the right
Uni-Loop connector on the camera. Similarly, a camera
carried on the left side sling will most often only need
to be connected via the left Uni-Loop connector on the
camera. In general, the Uni-Loop connector on the
opposite side is only used for cameras with battery
grips. The lengths of the slings can be adjusted with
the triglide buckles towards the rear of the harness. The
additional triglide buckle on the sling functions as a stop
to keep your gear from sliding too far back. It can be
adjusted to your preference.
The Triple Carrier™ is great for cameras or binoculars
© 2014 OP/TECH USA
02029261 - Pg 1 of 2
Rev B 11-17-14
![](/html/a9/a9a7/a9a72aca21618a9829c1a3a6aa25592f6063bd4c3827b9294fe8bbac24deef82/bg2.png)
3. For carrying gear in the center position, connect the
center straps to the inner quick disconnects on the front
of the yoke.
4. It is recommended to wear the torso strap especially
when using the center position strap. This keeps the
weight of your gear from creeping up onto your neck.
The Torso Straps fasten to the lower quick disconnects
on the back of the harness, then come together in
front of your body and fasten with a quick disconnect
for convenience. The Torso Strap can be adjusted
for the most comfortable t. The adjustability range is
approximately 26" - 57" (66-144,8 cm) long.
Torso Strap
Torso Strap
Sling
Sling
Torso Strap fastens in front with
quick disconnect
5. Carrying gear on two slings allows for quick access
to two cameras, or a camera and pair of binoculars.
6. To carry a single piece of gear on a sling, you can
remove the opposite sling and replace it with the
3/8" wide Under-Arm Retaining Strap. This strap is
adjustable from approximately 12" - 21" (30,5 - 53,3
cm). Cinch this strap to keep the yoke in place on the
shoulders during use.
7. If you would like to use one of the side positions to
carry a tripod, you can attach a pair of OP/TECH
USA's System Connectors™ - Tripod Loops (sold
separately).
Two Slings
One Sling with Under-Arm
Retaining Strap
System Connectors™ -
Tripod Loops
(sold separately)
8. If the Triple Carrier becomes soiled it can be hand
washed in mild detergent, rinsed thoroughly and set at
to dry.
© 2014 OP/TECH USA
02029261 - Pg 2 of 2
Rev B 11-17-14