Opkon OP-CN4 User Manual

ELECTRICAL CONNECTION

Manufacturer:

Terazidere Mah.60.Yil Cad.No:5/3

34035 Bayrampasa/ISTANBUL/TURKEY

MODEL OP-CN4

UNIVERSAL

INCREMENTAL

COUNTER

Ver 2.0E

USER GUIDE

WARNING!

READ CAREFULLY BEFORE POWER ON

1. Complete electrical connections according to the

schematic at the last page.

2. Check Supply Voltage 220V (or 24V optional) AC, or DC, due to

Specifications on the equipment.

3. Use only shielded cable for sensors.

4. Keep away the equipment from direct heat source.

5. MODEL OP-CN4 is not suitable for outdoor use.

6. Keep away the equipment from water or other liquid

drains.

7. Do not open, modify or replace any component in the
equipment, If any problem occurs please contact an authorised
OPKON technical service or OPKON directly.

ELECTRICAL SPECIFICATIONS:

Microcontroller based
A /B /Z(Reset)-4 X Counter mode
200 kHz Max. counting frequency
2 X Relays output
1 X SSR output
Incremental or absolute positioning mode
Holding on the last value in memory
10 X Output modes
Offset calibration
Password to protect menus

Power Supply :220V ± % 20 (or 24V optional) ,50 Hz
Power Consumption :<4 VA (protected by fuse 50mA)
Sensor supply voltage :+5V or +12VDC (selectable by jumper)
Sensor supply current :Max.100mA(no fuse)
Relays max. ratings :Relay1 1xNO+NC 8A,230V AC

Relay2 1xNO+NC 8A,230V AC

SSR output :5V DC (non-isolated)

MECHANICAL SPECIFICATIONS:

Dimensions :72x72x90 mm
Panel cut dimensions :67x67mm

Body :ABS plastic
Working temperature :0-60 ºC
Storage temperature :-10ºC …+80ºC
Humidity :<%90 RH

DESCRIPTIONS

BUTTONS

1. Resets the counter.

2. Escapes from program menu. COUNTER DISPLAY

1. Enters to program menu.

2. Shifts the rows When
programming parameters

PARAMETER DISPLAY

1. Travels in menu.

2. Changes the program

LED INDICATORS

Turns on when equipment programming Indicates Communication RS232(optional).

Turns on when press RST button. OUT1- OUT2 İndicates that Relay1- Relay2 is activated

Indicates that the value on counter display A-B indicates the A-B counting inputs from sensor
is Incremental value. By presing UP/DOWN

buttons you can see calibrated value.

MODEL-CN4 MAIN MENU

When normal working mode ;

-Press SET button to Enter Main Menu

- Upper display shows Count value, - Press UP/DOWN buttons to see all

- Lower display shows SET1 Parameter value Parameters in the Menu

MODEL OP -CN4 OUTPUT TYPES