Opkix OPK1 User Manual

This device complies with Part 15 of the FCC Rules and Innovation, Science and Economic
Development Canada License-exempt RSS standard(s). Operation is subject to the following two
conditions: 1) This device may not cause harmful interference, and 2) This device must accept any
interference received, including interference that may cause undesired operation.

Cet appareil est conforme aux normes RSS exemptes de licence d'Innovation, Science et
Développement économique Canada. Son fonctionnement est soumis aux deux conditions
suivantes: 1) cet appareil ne doit pas provoquer d'interférences, et 2) cet appareil doit accepter
toute interférence, y compris les interférences susceptibles de provoquer un fonctionnement
indésirable de l'appareil.

Changes or modifications not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

This portable transmitter with its antenna has shown compliance with FCC/ISED SAR limits for
general population / uncontrolled exposure. The maximum listed SAR level is 1.28 W/kg (body).

Cet émetteur portatif avec son antenne a démontré la conformité aux limites SAR de la FCC/ISED
indicateurs pour la population générale/exposition non contrôlée. Le niveau de SAR indiqué
maximum est 1.28 w/kg (corps).

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

- Consult the dealer or an experienced radio/TV technician for help.

THIS DRAWING CONTAINS INFORMATION PROPRIETARY TO OPKIX INC. ANY UNINTENDED REPRODUCTION, USE, DISCLOSE. OR TRANSMITTAL OF INFORMATION WITHOUT EXPRESSED WRITTEN CONSENT IS PROHIBITED BY LAW.