Page 1
Tactical Hemorrhage
QUICK START GUIDE
Control Trainer
Equipment Identication
1
+ Simulator + Battery Pack
and Charger
+ Hand Pump
(for blood)
To get started, please follow these easy steps:
Charge Battery
2
+ Plug into a standard electrical outlet. The red light
indicates charging.
+ Charge the batteries for 6 to 8 hours (or overnight).
The indicator light turns green when the batteries
are fully charged.
Add Blood to the Simulator
3
+ Fill the reservoir on the hand pump with simulated blood.
+ Lift the penis and extend the blood fill port.
+ Attach the blood fill hose by snapping onto the blood fill
port on the simulator located under the penis. (Be sure the
hose nozzle is free of debris.)
+ Retract the handle and pump approximately three times or
until the simulator’s blood reservoir is full.
4 Install Battery
+ To install the battery pack, remove the skin cover on the
upper left thigh to access and open the compartment.
Then, attach the pack to the connector, and place the
pack inside the compartment.
Page 2
Tactical Hemorrhage Control Trainer
QUICK START GUIDE
5
Powering On
+ Press the on/off switch located in the battery compartment.
The light will turn blue when it is on.
+ Allow simulator to cycle through the powering up sequence
+ Close the battery compartment and replace the skin.
6
Running the Blood
+ Use the remote “key fob” controller to turn the blood
flow on and off. Hold down the top button for
blood flow “on” and release for “off”.
Questions and Support
Contact us if you have a question or need help
with your simulator.
Phone: (410) 287-5748
Email: support@operativeexperience.com
operativeexperience.com | 500 Principio Parkway West, Suite 900 | North East, MD 21901 | 410-287-5748 © 2018 Operative Experience, Inc.
Loading...