Opera Audio M100S plus, Cyber300BD, PM-2, Cyber-222 MKII, R880 User Manual

M100S plus

SAFETY INSTRUCTION
To avoid personal injury or damage to equipment, please

ensure that you read this manual in its entirety before
attempting to operate the equipment. Please retain this
manual for future reference.

TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT
UNDER ANY CIRCUMSTANCES REMOVE ANY PARTS OF
THE EQUIPMENT COVER. THERE ARE NO USER
SERVICEABLE PARTS INSIDE. ALL SERVICING MUST BE
CARRIED OUT BY QUALIFIED SERVICE PERSONNEL.

WARNINGS

Power Source

The equipment should be connected to a power supply only of the type described in this
manual or as marked on the equipment.

Do Not Disassemble

Do not attempt to service the equipment beyond that described in this manual. Touching the
equipment’s internal parts could result in severe personal injury. All other servicing or
problems as listed below should be referred to qualified Consonance service technicians:

• The power supply cord or plug has been damaged

• Objects have fallen or liquid has been spilled into the equipment

• The equipment does not appear to function normally or exhibits a marked change in

performance

• The equipment has been dropped or the enclosure damaged
Do not under any circumstances allow anyone to modify your Consonance equipment without
first checking with Opera Audio, your dealer, or your distributor. Unauthorized modifications
will invalidate your guarantee.

This icon marks a presence of un-insulated “dangerous voltage” within the product's enclosure
that may be of sufficient magnitude to constitute a risk of electric shock to persons.

This icon marks important operating, maintenance and service information that should be
read to prevent possible personal injury

Grounding or Polarization

Power supply cords should be routed so that they are not likely to be walked on or pinched by
items placed upon or against them, paying particular attention to cords and plugs,
convenience receptacles, and the point where they exit from the amplifier.

Power Lines

In case of connecting a tuner, an outdoor antenna should be located away from power lines. If
an outside antenna is connected to the system, be sure the antenna is grounded so as to
provide some protection against voltage surges and built up of static charges.

Lighting

Consonance hi-fi system can be damaged by lightning. Power amplifiers are particularly at
risk and therefore should be turned off when there is risk of lightning strike. For complete
protection all mains plugs and any aerial cables should be disconnected when not in use.

Cleaning

Never clean with furniture polish, benzene, or volatile liquids. Dust periodically with a clean,
soft paint brush. Fingerprints can be removed with a moist polishing cloth.

Speaker Impedance

For best performance, the load presented by the speaker has to match the M100SPLUS’s
output impedance per channel. Refer to the speaker’s manufacturer handbook for information
on the nominal impedance. The M100SPLUS is factory set to match the speakers at 8 ohms

Ventilation

The equipment should be situated so that its location or position does not interfere with its
proper ventilation.

1. The equipment must not be placed on bed, sofa, or similar surfaces, that may block the
ventilation openings,

2. The equipment must not be placed in a built-in installation, such as a bookcase or cabinet
that may impede the flow of air.

3. The equipment should be situated away from heat sources such as radiators, heat
register, stoves, or other electronic appliances that produce heat. This equipment is not
intended for commercial use.

Water and Moisture

The equipment should not be used near water, e.g., near a bathtub, washbowl, kitchen sink,
laundry tub, in a wet basement, or near a swimming pool etc. Similarly, do not placed objects
filled with liquid, such as vases on top of the equipment.

Table of Contents

SAFETY INSTRUCTION

1. INTRODUCTION 2

2. UNPACKING & SET-UP 2

3 OPERATING TIPS 3

4. GENERAL WARNINGS 4

5. TROUBLESHOOTING GUIDE 4

6. REMOTE CONTROL 4

7. TECHNICAL SPECIFICATION 6

8. WARRANTY 7