OpenPeak OPOF2H02115, OPOF2B02110 Users Manual
OpenFrame™2.0
Quick Start Guide
© 2009 OpenPeak. All Rights Reserved.
1
What’s Inside
BOX CONTENTS
1. OpenFrame 2.0 base
2. Cordless handset
3. Handset charging cradle
1
2
3
4. OpenFrame 2.0 base power adapter
5. Handset cradle power adapter
6. Handset battery
7. Ethernet cable
8. Cleaning cloth
4
5
7
6
8
2 3
© 2009 OpenPeak. All Rights Reserved.
Base Unit & Cradle Setup Handset Setup
STEP 1
Choose Wireless or Ethernet
Connection
Place the base unit on a at surface
within signal range of your wireless
router, or plug directly into router
using the supplied Ethernet cable.
Ethernet cable for wired
connection only.
4 5
STEP 2
Power Up
Attach the supplied power adapter
to the back of the base unit and
plug into power outlet. The base
unit will automatically begin the
power-on sequence.
STEP 3
Plug in the Handset Cradle
Attach the supplied power adapter
to the back of the handset cradle
and plug into a power outlet.
© 2009 OpenPeak. All Rights Reserved.
STEP 4
Insert Handset Battery
A) Slide battery cover o the back
of the handset to expose the
battery compartment.
B) Locate the handset battery with
the attached red/white wires.
A B C
Plug the white connector tip of the
wires into the corresponding slot
inside the battery compartment.
Snap battery into place inside
compartment.
C) Replace the battery cover.
STEP 5
Charge the Handset
Place the handset in the cradle. You
should see the battery icon on the
display screen that indicates the
handset is charging.
Charge the handset in the cradle
for a minimum of 12 hours prior to
rst use. For best results use the
handset until the battery is fully
depleted before recharging.
Loading...