OpenEye OE4-KIT8, CM-610, OE4-KIT4, CM-710 Quick Start Manual
1, 2, 3
QUICK START GUIDE
AS EASY AS
FREE
VIRTUAL
INSTALLATION
SERVICE!
CONTENTS
Before proceeding, please check that the box contains the items listed here. If any item is missing or
has defects, DO NOT install or operate the product and contact your dealer for assistance.
4 Camera Kit (OE4-KIT4)
4x CM-610
8 Camera Kit (OE4-KIT8)
6x CM-610, 2x CM-710
4 Camera Kit (OE4-KIT4)
1x 8 Port PoE Switch
8 Camera Kit (OE4-KIT8)
1x 24 Port PoE Switch
Quick Start Guide and
Installation Software CD
1x white Cat5 cable
4 Camera Kit (OE4-KIT4)
4x blue Cat5 cable
8 Camera Kit (OE4-KIT8)
8x blue Cat5 cable
OpenEye makes network video
as easy as 1, 2, IP!
Need help?
Contact support
support@openeye.net
www.openeye.net/12ip
888-542-1103
faq.openeye.net
Jumping head first into the world of IP video can be a challenge. IP video involves learning and
understanding countless new concepts such as networks, IP addresses, and port forwarding. If you are
new to IP video it may all seem like a bit too much to handle, but don’t be alarmed, OpenEye is here to
make it easy for you.
OpenEye has developed a series of IP camera kits that walk you through the installation process and
help configure your system for you, drastically reducing the time and expertise needed to install an IP
solution. New users and veterans alike will appreciate the time saving benefits our Easy as 1, 2, IP
kits have to offer. If you do run into any problems along the way, just contact our Virtual Installation
Hotline at 1-888-555-3343. We are always here to assist you!
Note: The OpenEye IP cameras in
your kit are preconfigured to record
15 IPS at 2MP. Refer to the chart
for the estimated recording duration
based on your camera kit and the
storage capacity of your recorder.
These figures are estimates. Adjusting
the camera settings will change the
recording duration.
Storage Capacity 4 Camera Kit 8 Camera Kit
1 TB
25 Days 12 Days
2 TB
50 Days 85 Days
4 TB
100 Days 50 Days
6 TB
150 Days 76 Days
8 TB
200 Days 100 Days
30137AC
Select Your Installation
Installation C
New camera kit with existing recorder and network.
This installation type adds the IP camera kit to an existing OpenEye recorder. If this
installation type applies to you, follow the instructions in the CONNECT section
page 6 and the CONFIGURE C section on page 14.
The first step is to determine the proper installation type for your needs. There are
three types of installations:
Installation A
New OpenEye recorder and camera kit with no other connections.
This is a standalone installation that only includes the IP camera kit and a new
OpenEye HVR or NVR. If this installation type applies to you, then follow the steps
in the CONNECT section on page 6 and the CONFIGURE A section on page 8.
Installation B
New OpenEye recorder and camera kit with additional connections.
This installation includes the IP camera kit, an OpenEye recorder and an additional
device connected to the network switch such as:
1. A modem or router for an internet connection.
2. A DHCP server that assigns your IP address.
If this installation type applies to you, follow the steps in the CONNECT section on
page 6 and the CONFIGURE B section on page 10.
page 5
SELECT
Need help? Contact our Virtual Support Hotline Phone: 888-542-1103 Email: support@openeye.net FAQ: faq.openeye.net • Web: www.openeye.net/12ip
page 4
Your kit includes Cat5 network cables so you can connect and configure the
cameras, switch and recorder prior to the actual installation. OpenEye highly
recommends this approach as it will simplify the overall process by having all
equipment close at hand during the connection and configuration process. After all
the devices are working properly, you can unplug them and install them in their final
locations.
Connect Your Devices
Connect power to switch
Connect power to recorder
Connect cameras to ports 2~5 (4 camera kit) or
1~8 (8 camera kit) on the included switch
Connect recorder to port 1 (4 camera kit) or
port 25 (8 camera kit) on the included switch
If using Installation B or C, connect switch to network using any
available port (6-24 depending on model)
Tip: The cameras
included in the 1-2-IP
camera kit are powered
by Power over Ethernet
(PoE). PoE allows you
to power your cameras
using the Cat5 cable and
a PoE compatible switch.
Power on recorder
CM-610
CM-710
page 7
SELECT
Need help? Contact our Virtual Support Hotline Phone: 888-542-1103 Email: support@openeye.net FAQ: faq.openeye.net • Web: www.openeye.net/12ip
page 6
page 7
CONNECT
Email: support@openeye.net FAQ: faq.openeye.net • Web: www.openeye.net/12ipNeed help? Contact our Virtual Support Hotline Phone: 888-542-1103
page 6
Loading...