Page 1
IMPORTANT:
RETAIN FOR FUTURE REFERENCE, READ CAREFULLY
Forest Friends
Table and Chairs!
Model # 095112-308
Page 2
3
Read all instructions before assembly and use of the Table and Chairs.
Keep instructions for future use.
Safety Precautions
WARNING:
THIS PRODUCT CONTAINS SMALL PARTS WHICH ARE FOR
ADULT ASSEMBLY ONLY.
AS SMALL PARTS ARE INVOLVED IN ASSEMBLY, CHILDREN
SHOULD BE KEPT CLEAR OF THE ASSEMBLY AREA.
IDENTIFY ALL PARTS AND FASTENERS. CLEAR AN AREA
ON THE FLOOR FOR ASSEMBLY AND PLACE A SHEET ON
THE FLOOR TO ENSURE THE TABLE AND CHAIRS WILL
NOT BE SCRATCHED DURING ASSEMBLY.
DISPOSE OF ALL PACKAGING MATERIAL IMMEDIATELY
AFTER THE TABLE AND CHAIRS ARE ASSEMBLED.
Due to variations in the style and design of our products, the photographs and illustrations
shown in this instruction manual are generic, therefore product fabrics, colour and
design may vary from images shown. CNP Brands reserves the right to alter product
specications without notice as a result of our ongoing policy of product improvement.
Contents
Assembly contents list
Assembly / Operating instructions
How to care for your Table and Chairs
Congratulations on your purchase of this
Oops Table and Chairs!
This product has been designed and developed with
safety, comfort and functionality in mind. Please take
the time to read this manual carefully before using this
product and keep it in a safe place for future reference.
Page 3
54
Supplied loose in box:
Assembly Contents
Check what you have received...
You have received 1 box. Please check the contents of the box against the list below. If anything is
missing, please contact Customer Service. In Australia, contact CNP Brands on 1300 667 137, in
New Zealand contact Wainhouse Distribution on 0800 567 5000.
Assembly / Operating Instructions
Assembling Table
1.
Table lid
x1
Allen key
x1
Table top
x1
Seat back panel
x1
Table leg
x4
Seat panel
x2
Seat back
panel
x1
Chair leg
x8
Bolt (48mm) x4
Place a table leg into position as shown in the image. Line up the
screw that is attached to the leg and insert gently into the
pre-drilled hole underneath the table.
Turn the leg clockwise until leg is rmly into position.
3.
Insert lid into the middle of the table as per image.
2.
Repeat the above step with the remaining 3 legs.
Turn the table upright.
PLEASE NOTE: Do not over tighten the legs.
Page 4
76
Assembly / Operating Instructions Assembly / Operating Instructions
Line up the holes in the rear of
the seat with the holes on the
underside of the back seat panel,
as shown in image. Insert 1 x screw
into each hole.
Tighten with supplied allen key.
1.
3.
Assembling Chairs How to care for your Table and Chairs
Cleaning
To ensure the long-lasting use of your Table and Chairs, wipe down with a damp cloth and
use a mild soap solution if necessary. Do not use abrasive cleaners. Always store product in a
clean dry place.
Maintenance
Always check parts regularly for tightness of bolts, nuts and other fasteners – tighten or
replace if required. To maintain the safety of your Table and Chairs, seek prompt repairs for
bent, torn, worn or broken parts. Use only those parts and accessories approved by CNP
Brands.
If you have any difculties in assembling the toy box, please contact our Service Department.
In Australia, contact CNP Brands on 1300 667 137, in New Zealand contact Wainhouse
Distribution on 0800 567 5000.
PLEASE NOTE: Do not over tighten the bolts.
Taking one leg at a time, line up leg with hole and turn clockwise.
Keep turning until leg is rmly into position. Repeat with
remaining 3 legs.
Follow previous steps for the second chair.
2.
PLEASE NOTE: Do not over tighten the legs.
Once all legs are assembled, carefully
turn the chair upright as shown in
image.
Your table and chair set is now complete.
Page 5
Distributed in Australia by CNP Brands, 20 Calarco Drive, VIC, 3030
Customer Service 1300 667 137 www.cnpbrands.com.au
Distributed in New Zealand by Wainhouse Distribution, 2-6 Argyle St,
Morningside, PO Box 41-014, St Lukes, Auckland, New Zealand
Customer Service: 0800 567 5000 [email protected]
Loading...