Page 1
LPT5000
ASSEMBLY INSTRUCTIONS
Computer Laptop Stand
Congratulations on your purchase of the LPT5000 Computer Laptop Stand.
Please read the following assembly instructions carefully. We hope you enjoy
your new purchase!
Parts
Remove all parts
from boxes
and identify:
Lower
Support (2)
Mounting
holes
Upper
Support
(2)
Assembly
1. Take one of the Upper Supports and place it over
one of the Lower Supports (See Figure A). Align the
Upper Support holes with the Lower Support
mounting holes to obtain the desired height. Place
one knob at a time through the mounting holes
(must be spaced at least 2 holes apart). Take a
Stabilizer Bar and screw the top knob into the end
of the Stabilizer Bar. R epeat with bottom knob .
Figure A
Stabilizer
Bar
(2)
Knobs
(4)
Place Upper
support over
Lower support,
so that the
Upper Support
is on the
outside
of the stand
Knobs must
be spaced at least
2 holes apart
2. Repeat above with the other Upper Support and
Lower Support for the opposite side of the stand
(see Figure B). Secure all knobs tight to minimize
stand wobble.
Y ou are now ready to use y our lap top stand.
®
Figure B
© 2007 TMP, Inc.
www.musicpeopleinc.com
www.onstagestands.com
Loading...