On Que Lighting Designs CNF DMX RGBW Operation Manual

Crash 'N Flash DMX Stage Lighting/Effects Systems

(CNF)

Technical information/operation manual

The CNF DMX RGBW Stage Lighting/Effects System consists of a CNF crash cymbal

trigger interfacing with the CNF DMX RGBW Lighting Control Module through its
four COLOR CODED 1/4” CNF TRIGGER INPUT jacks. Accepting up to 4 (8 with

standard 'Y' cables' ) CNF crash cymbal triggers.

The CNF DMX RGBW stomp box Stage Lighting/Effects Module is a DMX

master/controller device, sending out an industry standard DMX data command and

connects to DMX slaves through its 3-pin XLR connector.

The CNF DMX RGBW Stage Lighting/ Effects Module has a blackout switch (stomp

button) which toggles between a blackout state and an operational state. On board

LED mode indicators signify operational state (GREEN-system active) or (RED-

blackout, power/standby). In blackout state, all connected DMX devices are

commanded to go to off.

The CNF DMX RGBW Lighting/Effects Module may be operated in 'stand alone'

mode as well without the use of CNF cymbal triggers for certain Stage Effects such as

foggers, lasers, DJ applications, etc. This mode requires a separate DMX interface

input module inserted into one (1) or more of the 4 color coded CNF trigger input

jacks. DMX output is then controlled solely through the footswitch stomp button

engaging 'system active' and 'blackout, power/standby'.

IMPORTANT!

RGB (multi-color) LED fixture addressing:

Set your LED fixture(s) to channel 3 mode with a DMX address of 1.

With master fixture and all concurrent fixtures set to this mode and address;

#1- CNF 'RED' input will cause up to 32 daisy chained fixtures to turn RED

#2- CNF 'GREEN' input will cause up to 32 daisy chained fixtures to turn GREEN.

#3- CNF 'BLUE' input will cause up to 32 daisy chained fixtures to turn BLUE.

#4- CNF 'WHITE' input will cause up to 32 daisy chained fixtures to turn a COMBINATION

of RED, GREEN, and BLUE resulting in a WHITISH hue.

#4-A !! All 'WHITE only' LED fixtures will ONLY be commanded by the #4

'WHITE' CNF DMX RGBW Lighting Control Trigger input. !!

IMPORTANT!

All 'WHITE only' LED fixtures/Blinders/Strobes,

Blizzard Snowblind White LED Blinder fixtures, etc...

Master fixture and up to 32 concurrent daisy chained fixtures must be

addressed to 'SLAVE' mode for proper operation. And ONLY commanded

by the #4 'White' CNF Trigger Input.

*** Color blending may also be achieved by triggering multiple inputs

simultaneously, for example PURPLE from RED and BLUE inputs.***

CNF crash cymbal Trigger, Lighting Control Module and LED fixture hook up

typical diagram...