Onn ONA11HO087 Product Manual
om
Wireless Keyboard and Mouse
with Nano Receiver
Federal Communication Commission
Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCCRules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference willnot
occur in a particular installation. Ifthis equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radiolTV technician for help.
This device complies with Part 15of the FCCRules. Operation is subject to the
followingtwo conditions:
and
(2)
this device must accept any interference received, including interference that
may cause undesired operation.
FCCCaution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority-to operate this equipment.
Wal-Mart Stores,lnc.,
Bentonville, AR 72716
Hotline: 1-800-925-6278
(1)
This device may not cause harmful interference,
III III III III III III III III III III IIIInIll.JIl
-
Model:
ONAllH0087
/
PRODUCT GUIDE
CAUTION: To use this product properly, please read the user's guide before installation
Keyboard Button
1.
LEDIndicator
2. Connect Button
3. Battery Cover
111111111111111111111111111111111
JILJII III III IILJIL..lI ['
,-
•
r·ej
.
•
.'
•
[_J
.
AAA
Batteries
•
l
e~
•
•
~
-
Mouse Button
1.
Left button
2. Right button
3. Scrolling Wheel
4. Backward
5. Forward
6. LED Indicator
7. Nano Receiver
8. Battery Cover
9. Connect Button
10. OFF/ON Switch
Forward
Press this button to view the next page of the Internet browser.
Backward
Press this button to view the previous page of the Internet browser.
Installing the batteries
Step 1:Take the battery cover off.
Step 2: Insert the batteries as shown inside the battery compartment.
Step 3: Replace the cover.
Step 4: Turn on power switch.
**Warning:
"Please insert the batteries with the correct position according to the instruction
labeled in the Keyboard / Mouse.
'The batteries shall not be exposed to excessive heat such as sunshine, fire or
the like.
Battery warning statement:
Do not mix old and new batteries
Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad,
ni-mh, etc) batteries.
OJ
Setup the Connection between the ~." ¢:l ~
Receiver and the Mouse, Keyboard ~~
1.Plug the Nano receiver into the USB port of your comput~
2. Insert the batteries into the mouse and keyboard, then your mouse and keyboard
will connect automatically.
3. If your wireless mouse and keyboard has not been connected to your computer
after completing the previous steps, then put them into pairing mode.
4. Pairing: Press the connect button on the bottom of the mouse and keyboard,
Ifthe mouse or keyboard does not work after 10 seconds, Re-pair again. Keep
the mouse and keyboard closer to the receiver while in pairing mode.
5. When the keyboard battery is low, the low power indicator will start to blink.
During pairing
LED Indicator
Red LED is on for 10 Sec. ~
\ Power On
Red LED Blinking for 10 Se..w_
\ Low Battery Warning
Red LED Blinking
Pairing (LED OFF when paired
or failed after 10 sec.)
-wr
"")I-
-.
Red LEDis on for 10 Sec. ~
\ Power On ~-
Red LEO Blinking for 10 Se..w_
\ Low Battery Warning
Red LEDBlinking
Pairing (LED OFF when paired
or failed after 10 sec.)
2
3
}I-
Loading...