Onkyo TXDS575MUTE User Manual
Title: TX-DS575
Classification: Service Tip
ONKYO USA CORPORATION
200 Williams Drive • Ramsey NJ 07446
201- 825-7950 Fax 201-825-8150
Symptom: Receiver shuts down when source is selected or volume is the MIN. position.
Solution: Defective components
Date: 11/21/99
Ref #: TXDS575MUTE
Referring to Page 41 and 42 of service manual find all location of muting transistors used. Anyone of
the following transistors at location Q3383, 3483, 3186, 3187, 3188, 3684, 3683, 3583, 3283, 3183
may be leaky. The emitter of any of the above-described components should not exhibit any DC volt
presence in excess of 12mv to max 20mv since it is tied to capacitor coupled signal line.
Mute duration is governed by C3194 and general muting contr ol DC volt (+2.6) passes through
Q3185. The base of all muting transistors is -12vdc when unit is operating normal. When in mute
mode, muting transistors base voltage goes to approximate +2.6vdc.
Repair Procedure:
Since the unit is likely to shut dow n if the above problem does happen, the following simple process
will keep the unit at ON state to provide troubleshooting ease. While the unit is off, disconnect P601
from the front and center power amplifier and connect a temporary ground line between P601and
P601A ground pinpoints. Disconnect P520 from surround amplifier and also connect ground wire
separately between P520 and P520A. This will keep the DC pulse from getting in to the amplifier
causing it to shut down.
For further amplifier safety one may short all amplifier inputs to the Ground (GND) found at the preamp/Volume terminal labeled P601A and or P520A. This also will reduce the HIGH input impedance
condition the amplifier may develop while under service (Troubleshooting) on the unit.
Loading...