Onkyo HTP-993, SKR-980, SKB-980, SKC-980, SKF-980 User Manual

En-1

En

HTP-993

7.1ch Home Theater Speaker Package

Make sure you have the following accessories.

Front Speakers (SKF-980)

Center Speaker (SKC-980)

*1

For use of front speakers and center speaker.

Surround Speakers (SKR-980)
Surround Back Speakers (SKB-980)

Powered Subwoofer (SKW-980/SKW-938)

Front

.

Rear

SKW-980 (North American models)

Supplied Accessories

Front speakers Speaker cables

3.5 m (11 ft.)

Center speaker Speaker cable 3.0 m (10 ft.)

12 cork stoppers

*1

(White)

(Red)

(Green)

Surround speakers Speaker cables

8.0 m (26 ft.)

Surround back speakers Speaker cables

8.0 m (26 ft.)

Subwoofer RCA cable 3.0 m (10 ft.)

(Blue)

(Gray)

(Brown)

(Tan)

Standby/On indicator

Red: Subwoofer in standby
mode
Blue: Subwoofer on

The status indicator lights
blue when low frequency
sound is being passed
through the speaker.
The indicator does not light
in the normal dialog or high
frequency sound.

Caution

• The front grille is not designed to be removed so do not
attempt to remove it forcibly, as this will damage it.

OUTPUT LEVEL control

This control is used to adjust
the volume of the subwoofer.

LINE INPUT

This RCA input should be
connected to the subwoofer pre
out on your AV receiver with
supplied RCA cable.

To AC outlet

En Fr Es

SN29402382_HTP-993_EnFrEs_1703xx.book 1 ページ ２０ １７年３月１７日　金曜日　午後２時５８分

En-2

SKW-938 (European models)

Caution

• With other audio-video components, connect the subwoofer’s
LINE INPUT to the subwoofer pre out jack of your equipment.
Never plug any kind of musical instrument to the subwoofer.

Note

• The Auto Standby function turns the subwoofer on when the
input signal exceeds a certain level. If the Auto Standby function
does not work reliably, try slightly increasing or decreasing the
subwoofer output level on your receiver.
When there’s no input signal for a while, the SKW-980/SKW­938 automatically enters Standby mode.

• If the Standby/On indicator lights (both red and blue LEDs)
several seconds or minutes after the sound output stopped, this
means that the amp protection circuit has been activated. In this
case, set the OUTPUT LEVEL control to the center position, and
disconnect the power cord from the AC outlet. Wait at least 10
minutes, and then reconnect the power cord. If that doesn’t solve
the issue, contact your Onkyo dealer.

Using the Cork Stoppers for a More Stable
Platform

We recommend using the supplied cork stoppers to achieve
the best possible sound from your speakers. The cork
stoppers prevent the speakers from moving, providing a
more stable platform.

Attaching and detaching the speaker grilles

The front, center, surround and surround back speakers
have detachable grilles.
See the illustrations to attach or detach them.

Setting the Subwoofer Level

Make sure the SKW-980/SKW-938
subwoofer

’

s output level control is set at
the “THX POSITION”. You can then
adjust the level as needed

.

Wall Mounting

To mount the front/surround/surround back speakers
vertically, use the keyhole slot shown to hang each speaker
on a screw that’s securely screwed into the wall.

To mount the center speaker horizontally, use the two
keyhole slots shown to hang each speaker on two screws
that are securely screwed into the wall.

Caution

• A mounting screw’s ability to support a
speaker depends on how well it

’

s
anchored to the wall. If you have
hollow walls, screw each mounting
screw into a stud. If there are no studs,
or the walls are solid, use suitable wall
anchors. Use screws with a head
diameter of 9 mm (5/16") or less and a shank diameter of
4 mm (1/8") or less. With hollow walls, use a cable/pipe
detector to check for any power cables or water pipes
before making any holes.

• Leave a gap of between 5 mm (3/16") and 10 mm (7/16")
between the wall and the base of the screw head, as

POWER switch

Press this switch to the ON
position to turn on the power.
Press it to the OFF position to
turn off the power.

OUTPUT LEVEL control

This control is used to adjust
the volume of the subwoofer.

To AC outlet

LINE INPUT

This RCA input should be
connected to the subwoofer pre
out on your AV receiver with
supplied RCA cable.

Before Using the Home Theater
Speaker Package

Cork stoppers

Bottom of the
SKC-980

Cork stopper

Bottom of the SKF­980

Removal

Replacement

SKF-980

SKR-980/SKB-980

Keyhole slots for

wall mounting

260 mm (10-1/4")

Keyhole slots for wall mounting

SKC-980

Wall

5 to 10 mm

(3/16" to 7/16")

SN29402382_HTP-993_EnFrEs_1703xx.book 2 ページ ２０ １７年３月１７日　金曜日　午後２時５８分

En-3

shown. (We recommend that you consult a home
installation professional.)

The Home Theater means that you can enjoy surround
sound with a real sense of movement in your own home —
just like being in a movie theater or concert hall.

.

• Refer to the operating instructions for your AV receiver
and other equipment for details about the placement of
the speakers.

Speaker Connection Precautions

Read the following before connecting your speakers:

• Turn off your receiver before making any connections.

• Pay close attention to speaker wiring polarity.
Connect positive (+) terminals to only
positive (+) terminals, and negative (–)
terminals to only negative (–) terminals. If the
speakers are wired incorrectly, the sound will be out of
phase and will sound unnatural.

• Be careful not to short the positive and negative wires.
Doing so may damage your amplifier.

Note

• When you connect the front high left and right speakers, prepare
for it separately, or use the surround back left and right speakers.

Enjoying Home Theater

1 Front speakers (SKF-980)

These speakers output front stereo sound.

2 Center speaker (SKC-980)

This speaker outputs center sounds such as dialogs
and vocals.

3 Surround speakers (SKR-980)

These speakers create back sound field.

4 Surround back speakers (SKB-980)

These speakers further enhance the realism of
surround sound and improve sound localization
behind the listener.





5 Subwoofer (SKW-980: North American models

/SKW-938: European models)

The subwoofer reproduces bass sounds and creates
rich sound field.

Connecting the Speakers

RR RLLL

Front speakers

Red

White

Green

Gray Blue

Powered

subwoofer

Surround speakers Surround back

speakers

Center speaker

Brown

Tan

SN29402382_HTP-993_EnFrEs_1703xx.book 3 ページ ２０ １７年３月１７日　金曜日　午後２時５８分

En-4

Powered Subwoofer (SKW-980: North American

models/SKW-938: European models)

Front Speakers (SKF-980)

Center Speaker (SKC-980)

Surround Speakers (SKR-980)/

Surround Back Speakers (SKB-980)

Specifications and appearance are subject to change
without prior notice.

THX and the THX logo are trademarks of THX Ltd.,
registered in the U.S. and other countries.

Use with a TV set

In general, Braun tubes used for color television sets, etc.
are extremely sensitive and can be affected even by the
magnetism of the earth. If a speaker system is used near
them, therefore, discoloring or distortion of pictures will
occur.

For magnetic shielded speakers (Front speakers, Center
speaker):

The speakers are shielded to prevent discoloration. In some
situations, however, discoloration may still be an issue, in
which case you should turn off your TV or monitor, wait
15 to 30 minutes, and then turn it back on again. This
normally activates the degaussing function, which
neutralizes the magnetic field, thereby removing any
discoloration effects. If discoloration problems persist, try
moving the speakers away from your TV or monitor.

For non-magnetic shielded speakers (Powered
subwoofer, Surround speakers, Surround back
speakers):

Try moving the speakers away from your TV or monitor. If
discoloration should occur, turn off your TV or monitor,
wait 15 to 30 minutes, and then turn it back on again. This
normally activates the degaussing function, which
neutralizes the magnetic field, thereby removing any
discoloration effects.

Specifications

Type Acoustic suspension
Rated output power

(FTC)

125 watts minimum continuous power,
6 ohms, driven at 100 Hz with a maximum
total harmonic distortion of 1% (SKW-

980)

Rated output Power
(IEC)

125 watts minimum continuous power,
6 ohms, driven at 100 Hz with a maximum
total harmonic distortion of 1% (SKW-

938)

Input sensitivity/
impedance

280 mV/20 k

Frequency response 20 Hz to 100 Hz
Cabinet capacity 49 L (1.73 cubic feet)
Dimensions (W × H × D) 380 mm × 444 mm × 429 mm

14-15/16" × 17-1/2" × 16-7/8"
(incl. grille and projection)

Weight 15.5 kg (34.2 lbs.)
Drivers unit 30 cm (12") Cone Woofer
Power supply AC 120 V, 60 Hz (SKW-980)

AC 230 V, 50 Hz (SKW-938)

Power consumption 140 W (SKW-980)

137 W (SKW-938)

Grille Fixed
Other Auto Standby function

Non-magnetic shielding

Type 2 Way Acoustic suspension
Impedance 8 
Maximum input power W
Sensitivity 83 dB/W/m
Frequency response 50 Hz to 45 kHz
Crossover frequency 2 kHz
Cabinet capacity 7.5 L (0.265 cubic feet)
Dimensions (W × H × D) 158 mm × 433 mm × 199 mm

6-1/4" × 17-1/16" × 7-13/16"
(incl. grille and projection)

Weight 5.3 kg (11.7 lbs.)
Drivers unit 12 cm (5") A-OMF Cone Woofer × 2

2.5 cm (1") Soft Dome Tweeter × 1

Terminal Binding post (Banana type supported)
Other Magnetic shielding

Type 2 Way Acoustic suspension
Impedance 8 
Maximum input power 130 W
Sensitivity 83 dB/W/m
Frequency response 50 Hz to 45 kHz
Crossover frequency 2 kHz
Cabinet capacity 7.5 L (0.265 cubic feet)
Dimensions (W × H × D) 433 mm × 158 mm × 199 mm

17-1/16" × 6-1/4" × 7-13/16"
(incl. grille and projection)

Weight 5.3 kg (11.7 lbs.)
Drivers unit

12 cm (5") A-OMF Cone Woofer × 2

2.

5 cm (1") Soft Dome Tweeter × 1

Terminal Binding post (Banana type supported)
Other Magnetic shielding

Type 2 Way Acoustic suspension
Impedance 8 
Maximum input power 130 W
Sensitivity 81 dB/W/m
Frequency response 50 Hz to 45 kHz
Crossover frequency 2 kHz
Cabinet capacity 4.6 L (0.163 cubic feet)
Dimensions (W × H × D) 200 mm × 275 mm × 169 mm

7-7/8" × 10-13/16" × 6-5/8"
(incl. grille and projection)

Weight 3.5 kg (7.7 lbs.)
Drivers unit 13 cm (5-1/8") A-OMF Cone Woofer × 1

2.5 cm (1") Soft Dome Tweeter × 1

Terminal Binding post (Banana type supported)
Other Non-magnetic shielding

SN29402382_HTP-993_EnFrEs_1703xx.book 4 ページ ２０ １７年３月１７日　金曜日　午後２時５８分