User manual
STEREO HEADPHONES
SE-E6BT
Bluetooth solution: WT200
Bluetooth version: V4.2
Bluetooth profiles: A2DP,AVRCP,HFP
CODEC: SBC
Speaker : 8mm
Operation distance: 10 meter
Battery: 80mAh VDL41030(400929)
Charging time: about 1.5 hours
Music playing time: 6.5 hours
Phone call time: 6.5 hours
Temperature : 5~40 ºC
==================================================================
1.Indicator
2 Volume+ / next chart
3． Volume - /previous chart
4． ON/OFF /play/pause
5． Usb 5 V Output
Feature:
Enjoy music through Bluetooth
Phone call with BT function
Remote control music
High sensitivity,omni bearing microphone design
Apply for devices:with all BT mobile phone,iphone,Laptop Etc.
Pairing:red&blue light blinking
Pairing successful:blue light slow blink
Charging: red light on, full charge LED light off .
一. BT earphone pairing
1.press and hold （ ）5s open Pioneer SE-E6BT,Lasting to red &blue light blinking,into paring mode
（noted :Paring need to finish in 5 minutes,after 5 minutes earphone will shut off automatic ）
2.Open the phone or Bluetooth device ,”Bluetooth search”or “add new equipment" search Bluetooth
headset Pioneer SE-E6BT “
3.Click on the device name connection, the connection has a successful connection tone and blue light
flashing. This means that the connection is successful.
二．Answer phone call
incoming call tone or ring tones, short press ( ), you can answer the call.Or use your phone to
answer a call.
三.Reject phone call
Short press ( ) or use the phone to stop the call .
四．.Last number redial
Double click ( ) to redial last number
五．Music playing
Short press “ ” paly /pause,long press +to next chart,short press + volume UP;long press -to
previous chart, short press - ,volume down .
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used
in portable exposure condition without restriction.
ISED Statement
‐ English: This device complies with Industry Canada license ‐ exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause interference,
and (2) This device must accept any interference, including interference that may cause
undesired operation of the device. The digital apparatus complies with Canadian CAN ICES‐3
(B)/NMB‐3(B).
‐ French: Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitationestautorisée aux deux conditions suivantes: (1) l'appareil
ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareildoit accepter tout
brouillageradioélec triquesubi, mêmesi le brouillageest susceptible d'encompromettre le
fonctionnement. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
Radiation Exposure Statement
This equipment complies with Canada radiation exposure limits set forth for an uncontrolled
environment.
Déclaration d'exposition aux radiations
Cet équipement est conforme Canada limites d'exposition aux radiations dans un
environnement non contrôlé.
Loading...